Check the starter button it may be full of carbon, remove it and clean wth a 400 sandpaper or better replace it.
Hope this helps
Testimonial: "Checked shutoff and starter switch with testor and they are working properly."
SOURCE: 05 katana new bat new starter new relay still
check these things: is the engine run/stop switch pressed? is the bike in gear? is your safety switch always depressed?
SOURCE: coils wont fire,and hit start button and wont turn
Try putting power to the small red on relay, this actuates the solenoid, if power now goes to starter its OK (if not replace). Then check the Start Button contacts are good - check for continuity across it - & all interlocks (neutral / clutch & side-stand switches) work OK. Also check for continuity between the start button & starter relay + from relay to solenoid
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
SOURCE: the bike will not start. when the key is turned on
Dismantle the switch block on the right bar, make sure nothing has gotten in and blocked the circuit. In the past I have found an insect in there where it's wings blocked the switch. Clean the contacts and it should work.
147 views
Usually answered in minutes!
×