F1 Flash on dashboard - 2000 Suzuki GSX-R 750

E-F1 is an error code. Cannot tell you what it is until you tell us what brand and model oven you have. All manufacturers codes are different. Try re-asking the question with the oven make and model information.

dashboard brake light flashing randomly - Forums.focaljet.com

forums.focaljet.com/.../662231-dashboard-brake-light-flashing-randoml...

May 14, 2012 - 12 posts
Car run great the only issue is the dashboard brake light is flashing randomly. ...Finally, the instrument cluster is hardwired to the ABS module, ... Also,i change the parking brake switch and the light goes on & off less frequent.

what does ABS flashing light mean at the dashboard of my 1996 ...

https://answers.yahoo.com/question/index?qid...

May 3, 2009 - What does ABS flashing light mean at the dashboard of my 1996 ... just hard enough to skid a tiny but, then back off a hair to stop skidding.

ABS Brakes Troubleshooting - How to Troubleshoot Anti ...

www.popularmechanics.com/cars/how-to/a461/2265091/

And in English BUT SORRY CANNOT HELP NEED TO CROSS THE PLUG WITH A WIRE TO GET FAULT CODE

Code F1 that means I changed the OIL AND SPARK PLUGS AND OIL FILTER PRIOR TO GET THE OLD OIL I PUT THE MOTOR A QUARTER OF LIQUID TO CLEAN THE ENGINE INSIDE. I OCMBIE BY SYNTHETIC OIL THE BIJIAS ARE CALIBRATED TO32--- O33. ALPRENDERLA WAS F1 IN THE DASHBOARD, I did a U-TURN ON THE MOTORCYCLE WORKS WELL IN LOW SPEED HIGH YEN LOSES FORCE THAT CAN BE?

You have a short within the wires of the turn signal switch and hazard switch. You might need a new dashboard

most commom problem for f1 is the tempreture sensor in oven, however also ive seen alot of clocks needs to be replaced for f1. without testing sensor im not sure witch one.

I remember correctly, F1 means the main board is bad.
Please rate solution

A lot of times it is the exup servo motor needing adjustment. It will cause the Fi read out to eliminate.

It sounds like the tilt cut off may be to blame. If you put the bike into self diagnosis mode it will give you a code. This code can be checked and the offending sensor replaced. The tilt sensor in the tail piece is one sensor that turns the fuel pump off and so stops the engine.

Try changing the CMOS battery (leave the battery out for 5mins then replace with new 1) if that does not work flash the BIOS

Let me know how you get on...
Matt

use trapAllKeys() command in the actionscript