Harley davidson 883 custom sportster signal light does not cancelle out when i turn the handle bars to the straight possition, when i turn on the bike signal keep blinking

SOURCE: I have Harley Davidson 2000 Sportster 883. I

Neg cable corroded thru.
I bet you have 12v at the battery and less at the other end of the neg cable.
I had the same problem.

Gar

• 384 Answers
• Posted on Jun 04, 2009

SOURCE: harley davidson 1200 custom sportster

Your alarm is on. If it's a HD alarm one long click turns it on and 2 short clicks turn it off.

SOURCE: harley davidson 1200 custom doesnt start and security light on the speedo blinks. i had earlier clicked on the remote. it is sportster 1200 custom-2005.

hold key fob until signals flash,check speedo for solid key light,then try...if it still does the same thing,battery could be too low(will cause this also)

SOURCE: how to set the timing for a 2003 883 harley

there is is no timing after static or set up timeing your ignition module controls timing and advance

SOURCE: 2007 harley davidson xl sportster 883 speedometer

If you're lucky it might be the speed sensor located in the gearbox casing. This is a hall effect device and is magnetic and so can pick up metal fragments from the inside of the gearbox. I have a 2001 Sportster and the Sensor is located on the top of the gearbox casing, just below the starter. I'd expect it to be in a similar position on a later bike such as yours, but I can't be sure. Once you've located it, take it out (can be a bit fiddly) and make sure that its clear of any debris. If not the sensor, you're probably going to need to substitute in a working speedo. Be careful because a pre-2004 speedo is electronic, but is not compatible with 2007 bike. Best of luck!