SOURCE: 2009 harley night train oil change instructions
i am not being a wiseguy, but if you buy the repair manual from harley, you'll have very easy to follow guides. the manual is $50. if that doesn't help cause of the price e-mail me and i'll walk you thru it..good luck and ride safe.
rande
SOURCE: 2006 Harley Street Glide turn signal problems
hi, if you have not yet fixed the problem , the fuse box is located underneath the left sidecover in front of the left sattlebag youll need to remove the bag to get the side cover off ck the fuses thats all it should be ,prolly what happened was a bulb went bad and shorted the circut blowing the fuse for them theyre on the same fuse as the tach and speedo
SOURCE: passenger seat on a Harley sportster nightster
main thing befor you drill the mounting hole, make sure its in the middle and the right spot. i did many accurate mods on harleys for ppl because you need a good eye, which most deaalerships dont have. place tape on fender, measure, mark, measure again then drill small hole, check, if good drill full size, if of , drag hole then drill.
SOURCE: REPLACINGTHE REAR TIRE ON A HARLEY DAVIDSON 2008 HERITAGE SOFTAIL
Down and dirty way - take it to the dealer and have them install a new tire....
The hard way: place bike on bike jack and remove rear wheel by removing the axle nut and drifting the axle out of the wheel. Derail the belt/chain and drop the wheel out of the brake caliper. Remove valve stem to deflate the tire. Get a set of tire spoons and a 12 pack of COLD brew cause working with tire spoons is no FUN! Pry the bead loose with one spoon and the work your way around the wheel prying the tire beed to the outside of the wheel. Repeat this process for the back side of the tire (in the same direction as the first side so the tire will come off the wheel. Reverse and repeat to install new tire.
By now you will be loading your wheel into the truck and heading to the HD shop. It just really isn't worth the hastle to save the $25 or so to have this job done.
Align wheel with new tire on it with the brake caliper so that you have one shoe on each side of the rotor (you may have to actually remove the caliper if your pads are thick. Install your belt drive/chain drive and then lift the wheel to insert the axle through the swing arm, the chain tensioner and wheel. Reverse
on the other side. Place axle nut on axle and torque to about 80lbs.
Good to go.
SOURCE: Replacement of a stock fuel gauge on a '06 Harley Street Bob.
no need to remove tank, Remove terminal pins from connector under left side of tank then pull gauge and wires out. Install new gauge, replace terminal pins in their propper place in the connector,plug it in and varify the repair.
333 views
Usually answered in minutes!
×