Question about Motorcycles

Open Question

2012 suzuki 400 King Quad cooling fan not coming on. Fan works and no blown fuses. I found a plug with 2 wires leading to lower crankcase where oil tubwe goes in. I unplugged it and fan came on.

Posted by Anonymous on


5 Related Answers

masterof o

  • 4 Answers

SOURCE: I have a Hunter 27185

you can use the red or the blk for blk,wht red

Posted on Mar 31, 2009



  • 83 Answers

SOURCE: my saturn l300 keeps blowing the #2 cooling fan fuse 30a

wiring may be shorting to a ground somewhere check wiring harness and connectors for a ground fault!!swampratt200!!AAAEE!!!

Posted on Jul 21, 2009



  • 146 Answers

SOURCE: Evap fan stops running/low cooling, Unplug Frig Evap fan runs

Is there anything obstructing the fan area, ice build up ? It is normal for your freezer to get warm if evap fan is not working, it is essential for it to work :) A defrost cycle should kick on a timer or as needed (adaptive) and there should not be excessive frost buildup that it blocks your evap fan. I would have suggested you unplug your refrigerator for about 10 minutes and see if that resets your control board - if not, then you will need service - either replacing motor assembly or a faulty control board.

Posted on Aug 22, 2009

Testimonial: "Thanks for your help. The control board was faulty. This is what I suspected but I wanted a second opinion before buying the board. "

John Bloomfield

  • 534 Answers

SOURCE: how to fix a blown rad fan fuse and relay for '99 concocorde

The seized radiator fan has probably caused the current overload that blew the fuse and subsequently damaged the fan supply relay.
Repair or replace the seized fan if possible.
If not able to replace/repair immediatley, temporarily leave the fan disconnected, but be aware it may cause engine to overheat when vehicle in operation and will definitly need to be fixed before the vehicle is fully serviceable.

Replace the fuse and fan supply relay if faulty and repair/replace any burnt wiring.
I would not recommend re-arranging the wiring or fuses in any way - as that may cause further damage - especially if you don't know exactly what you are doing.

Posted on Oct 27, 2009


  • 51 Answers

SOURCE: Toro Z Master Cooling fan will not turn on.

i would check water temp sender in engine block or thermostat housing.take wire off with key switch in on position touch wire to clean ground tis completes ground curcuit to relay fan should come on if so test sender with test lite or ohm meter. should be open curcuit or no lite when cold and go complete or lite when comes up to temp. clamp test lite to sender and probe to positive. hope this helps

Posted on Jul 18, 2010

Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2011 suzuki king quad 400 FSi the cooling fan does not kick on, any suggestions would help

coolant temperature sensor , fan relays , fuses and problem wiring would be a place to start checking

Oct 09, 2017 | Suzuki Motorcycles

1 Answer

Tempstar Air Conditioner wont come on

Sounds like you need a new contactor in the condenser. The low voltage is grounded. Remove the low voltage (likely 2 wires) at the condenser and wire nut the wires leading inside. With an insulated screwdriver manually push in the contactor and be sure both compressor and fan run. Then replace fuse and turn power on to air handler with a call for cooling. Obviously the outdoor unit won't run because you unhooked the low voltage but if fuse doesn't trip then it's likely the contactor. Good Luck

If you need further help, reach me via phone at

Apr 10, 2017 | Heating & Cooling

1 Answer

Suzuki eiger 400 is overheating

sounds like your thermal switch that controls the fan isnt working, that would be the first place to look, try connecting the two terminals to the thermistor and see if the fan comes on, good luck

Jul 24, 2012 | Motorcycles

1 Answer

I have a 2008 Suzuki ATV King Quad 400 - everything works fine except the ignition fuse keeps blowing. I used to be able to change it & it worked for a while but now today everytime I put a new fuse in...

I had same problem on mine, just discovered there is another hidden 30 Amp (green) fuse that was blown. If you follow the red cable from the battery, you will find a connector module. Lift that module out and disconnect the wires leading to the rear of the ATV (one plug, pulls out easily). You will see a semi-transparent plastic cover on this module, remove it and you'll see the 30 Amp fuse and the cover should have a spare in it. Replace the fuse, cover, and plug the wires back in - re-seat the module and see if it starts.

I'm still not sure what is causing all these problems, I'm suspecting it could be a bad battery. For now just carrying a lot of spare fuses.

Aug 10, 2009 | Sport & Outdoor - Others

1 Answer

95 Saab 900

If the low speed fan doesn't come on, but the system works when cooling air is blown through it, that says that whatever temperature sensor is used is working. It also seems that, if the fuse is OK, then the switch for the fan isn't working. There should be a switch module down there near the fan (you'd see wires from the fan to a harness, and it'll plug into a module). I'd be willing to try replacing that switch and see if it solves the problem.

Jun 20, 2008 | 1995 Saab 900

2 Answers

Engine overheating

did u check that the related fuse location spark?it could be your fan wire that lost connection with the power supply.

Jun 18, 2008 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

748 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers


Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides