At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Engine runs and idles but wont rev up all engine dies??
Battery was replaced bike starts and idles soon as u touch the throttle engine dies carb is spotless air filter is spotless and so is air box spark plug replaced bike only has 300 miles ???
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Pumping the primer bubble while the engine is running should cause the engine to over fuel and stall (if the tuning is correct). Sounds like its not fueling enough, pumping the primer is forcing fuel through the carb causing the engine to pick up rev's, but this is soon exhausted which is why it wont rev on the throttle. * Check that the fuel line is not damaged and drawing in air. (if this is intact try the next step) * Strip and clean the carb. Replace any diaphrams if needed. * Check gaskets seal between carb, air filter and cylinder.
Just out of curiosity what standard carb settings did you use.?
vacuum leak.....get some carb cleaner an when you can get the bike to idle somewhat normal spray around hoses and intake manifolds...if idle increases that where the problem is.
You need to fix the fueling first - without fuel it won't run!
Your other problem sounds like an air leak - either the manifold or the carb. Check by spraying WD-40 or CRC at the manifold and carb join while the bike is running - if the revs change (either up or down) you have a leak.
ALWAYS have a fire extinguisher on hand when working on carburetors. Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ). Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Before putting the slide back in the throat of the carb, move the clip on the jet needle one notch lower. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.
×