Question about Motorcycles
TOOK CARB OFF DID NOT MARK HOSES . [CRAZY] RIGHT.NEED DIAGRAM HOW TOO PUT HOSES BACK. THANKS.
Posted by Anonymous on
SOURCE: Re-connecting Vacuum Head
on the kirby head is a square knob with the kirby name on it. use your finger and pull out the belt and rotate the knob until the metal pawl engages the belt. keep turning until it stops. the belt should be in the correct position to install the head. place the whole head onto the lower two tangs and lift up. now rotate the wedge clamp until it stops. then rotate the belt lifter till the knob is straight.
Posted on Aug 29, 2007
try this website to see if they have your car listed its www.autozone.com if you are not able to get it try your local library or local chevrolet dealership in the parts department
Posted on Apr 27, 2009
Depending on your carb, distributor and transmission, you have from zero to two vacuum hoses.
If you have an Autostick transmission, there's a vacuum hose running from a port in the intake manifold to the control valve on the left side wall of the engine bay. (Hint: if you've got a car that came with Autostick and that someone's converted to manual transmission, the bracket for the control valve is the perfect place for your coil.) Most people don't have this transmission even if their car came with it--it's only a three-speed and it's hard to find parts for it, so most of those cars have been converted to manual transmission.
The other hose you might have is for your distributor. The port is on the left side of the carb, and a hose runs between it and the metal vacuum advance can on the side of the distributor. If you have a 009 distributor or an aftermarket distributor like an MSD you don't have the vacuum advance can; if you have an aftermarket carb like a Weber you don't have the port. Therefore...you probably don't have any vacuum lines on your engine.
if only one vacuum line then? the vacuum line goes from the vacuum advance on the side of the dizzy, to the carburettor, just around the throttle linkage if i recall. hope this helps.
Posted on Aug 11, 2009
Check out the autozone.com website and register the truck there. It doesn't cost anything and will give you access to an online repair manual for the truck. The vacuum diagrams should be available there. Hope this helped and best wishes.
Posted on Aug 30, 2009
Tips for a great answer:
Apr 01, 2016 | Mazda Cars & Trucks
Sep 20, 2014 | Garden
Sep 07, 2013 | Cub Cadet Garden
Sep 09, 2012 | Poulan Pro 14" Gas Chainsaw 33CC P3314
Jun 17, 2011 | Honda VF 750 C Super magna Motorcycles
Mar 08, 2010 | 1982 Ford F 150
Sep 13, 2009 | 1983 Suzuki Gs 550 L
May 31, 2009 | Bissell 7901-1 ProHeat Scotchgard Upright...
330 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: