How do you set carbs on a 2001 650 Yamaha Dragstar
SOURCE: problem with shaft drive (cardan) for my Yamaha Dragstar
SKU: 5FB-Y4617-00-00
SHAFT DRIVE SUB ASSY
SKU: 5FB-Y4617-00-00
SHAFT DRIVE SUB ASSY
Hi i just checked on stadium yamaha site and above is the SKU # for both, 98 and 03.... both the same so go for it
http://www.stadiumyamaha.com/pages/parts/viewbybrand/parts.aspx
SOURCE: carburetor adjustments yamaha 450yfz 2004
Turn both the air screw and throttle screw inward until they LIGHTLY seat. Now back each one outward one and one half turns. This is the factory setting. I am going to give you a web site where you can download a free PDF factory service manual for a YZ450FR. I believe the model is a bit different but the carbs are the same.
Go to this site and you can download a free PDF service manual. The site may take up to 25 seconds to fully load the list of manuals. It is worth the wait. www.carlsalter.com/motorcycle-manuals.asp The service procedures are there in detail and a lot of diagrams and photos. Don't mess with the pilot screw unless you have to, Part #11 in the diagram.
Can I get a Very Helpful" rating out of this?
SOURCE: 02 Yamaha xvs 650 dragstar classic that misfires when it warms up
First I would change all the spark plugs, and if that didn't make a difference then it sounds like the coil(s) are warming up and breaking down........when it starts to skip take a good pair of pliers with good rubber on them and pull each spark plug wire, when you get to the one that the running doesn't change then I would replace that particular coil
SOURCE: 1999 yamaha dragstar paint
Go to a local FinishMaster store and they will use a color eye to find u a color
SOURCE: how do you set the carburetor screws on a 1984 60cc yamaha 3
Half right, one is the idle the other is the air mixture screw, which really only affects idle mixture. The mixture screw is usually about 1.5-2 turns out from screwing it all the way in. then when the bike is idling it is adjusted by screwing it in a little until it bogs down (rich), then screwing it out a little until the engine revs up and down(lean) and finding a smooth engine speed in the middle.
To initially set the idle, look down the carb throat and screw it in until it just starts to lift the slide.
But this doesnt help the starting problem, there may be a blockage in the carb, or if you have cleaned that already, may have to check further, many of those smaller engines need the suction though the standard air cleaner to run properly
1,071 views
Usually answered in minutes!
×