Torque setting for cylinder head on a yamaha tzr 50

Yamaha tzr 50 cylinder head torque setting

5 Related Answers

Anonymous

109 Answers
Posted on Dec 05, 2008

SOURCE: Need cylinder and cylinder head torque specifications 98 XR 250

you dont need torque specs on that just use a 1/2 inch drive with you 14mm or16mm socket hold the wratchet right at the top and tighten it as tight as you could get it like that then use wratchet in normal position and just give it a little snugg it will be perfect i have done it a million time on the same type of bikes...

1400Slugg

260 Answers
Posted on Jan 04, 2009

SOURCE: Need torque wrench settings for cylinder head bolts

try here http://www.manualz.info/

hope this helps

Anonymous

302 Answers
Posted on Oct 13, 2009

SOURCE: torque settings for tzr 125 please

A service manual is a valuable tool with an aging bike. I suggest the dealer/mfr. or Clymer books. In the meantime, go to the library reference section...646 stacks should have what you need.

Anonymous

90 Answers
Posted on Jan 08, 2010

SOURCE: What are the torque specs for the cylinder head...

http://www.servis.offmoto.com/Manualy/KTM/2008/KTM%20125_200_250_300%20SX_EXC_XC-W%20Service%20info%20-%202008/KTM%20125_200_250_300%20SX_EXC_XC-W%20Service%20info%20-%202008.rar

I think you will like this.

Anonymous

7 Answers
Posted on Mar 12, 2010

SOURCE: head bolts tourque settings yamaha dtr 125

cylinder head nuts = 16 lbf ft - 2.2 kgf m cylinder barrel nuts = 20 lbf ft - 2.8 kgf m
please vote

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

What is the torque pounds for a 2003 v Star 1100 head bolts

Details here on Page 94

11. Following the tightening sequence shown in
Figure 15, torque the fasteners in 1/2 turn increments and in two stages to the specifications.
Torque the fasteners to 1/2 the given torque, then
torque them to their final specifications:
a. Cylinder head nuts (1-4, Figure 15): 50 N•m
(37 ft.-lb.).
b. Cylinder head cap nut (5, Figure 15): 35 N•m
(26 ft.-lb.).
c. Cylinder head bolts (6 and 7, Figure 15): 20
N•m (15 ft.-lb.).
12. If the cylinder has also been reinstalled, torque
the cylinder bolts (A and B, Figure 23) to 10 N•m
(89 in.-lb.). One of the bolts sits in a recess (B, Fig-
ure 23) in the cylinder block.
13. If removed, install the locating pin (B, Figure
21) into the camshaft