How do i take out the seat retainment nut off the rear fender?
SOURCE: correct torque for rear axle nut on 1997 harley davidson fat boy
Harley manual says 60-65 ft lbs... do NOT exceed this or wheel could seize
SOURCE: how to adjust rear brake/2005 harley 883xl sportster
There is a pedal height adjustment on the right side of the bike. If your brakes are dragging or not applying properly, you have a caliper problem, blocked line, bad master cylinder or mis-adjusted master cylinder plunger.It does have the correct DOT 5 fluid at the recommended level, right?
SOURCE: passenger seat on a Harley sportster nightster
main thing befor you drill the mounting hole, make sure its in the middle and the right spot. i did many accurate mods on harleys for ppl because you need a good eye, which most deaalerships dont have. place tape on fender, measure, mark, measure again then drill small hole, check, if good drill full size, if of , drag hole then drill.
SOURCE: how to change brake pads on a 2005 1200 Harley
there is 2 bolts on the caliper take them off and there are pad pins that need to be taken out.. inside the caliper there is a metal clip where the pad sits in.. put them in the same way they came out once you start its pretty self explainatory.. you should not have to blead them
SOURCE: diagram for 1984 harley sportster
contact me directly and I can scan a parts diagram for you
wd4ity @ bellsouth.net
145 views
Usually answered in minutes!
×