Motorcycles Logo

Related Topics:

A
Anonymous Posted on Jan 07, 2013

Turn on starter and knocks but will not turn over

Bike maintain in garage, cool, turn the starter engine light goes out, oil light stays on, hear knocking when turning the starter?

5 Related Answers

Anonymous

  • 667 Answers
  • Posted on Mar 23, 2009

SOURCE: engine knocking on toyota corolla after replacing damaged sump

oil pan and sump damage are very likely to lead to oil distribution problems, this is not temporary, if you hear a knock have it checked by a local mechanic who can verify it for you, it is possible that the engine is damaged internally.

Ad

Anonymous

  • 35 Answers
  • Posted on Jun 01, 2009

SOURCE: No oil Pressure, with knock. then oil pressure returns after turning off engine for a few minutes and cranking back up again.

is oil filter clogged???

Anonymous

  • 150 Answers
  • Posted on Jun 14, 2009

SOURCE: 2001 H-D Road King engine knock

01road king..probably have 30 to 40 thousand on it...Sounds like cam chain tensioner..about the only thing that will go wrong with your bike. I will assume you have oil etc in it...If you have not been running your bike stupid then nothing mechanical will usually brake on a Harley. Once again I assume its stock. You don't have an oil light on so I'll put my money on cam chain tensioner has exploded or is about to.

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Jun 14, 2009

SOURCE: Slight engine knock

ck your oil for floating bearing material and run good fue. If oil is clean, run it out, It may just be furl ossuesl

GM Elec

Bruce Bracey

  • 1000 Answers
  • Posted on Aug 22, 2009

SOURCE: engine knock hard over 2500 rpm

Does the oil light come on or the knock occur during the engine warm up after a cold start?
There could be a couple of problems causing the issue. You could have an oil pressure pump or pump pressure regulator sticking. I would have a mechanical oil pressure gauge installed and verify oil pressure at idle and 2500 rpms to make sure oil pressure is in normal ranges.
You could also have excessive piston rod bearing, crankshaft bearing or cam shaft bearing wear that will cause oil pressure to drop too low to prevent the rod knock your hearing at 2500 rpm.
You said a knock and not a ticking noise,so I don't believe a lifter is the issue at 2500 rpm.
Start with the oil pressure check and go from there.
Let me know.
Regards,

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Whining humming noise under hood

If the engine is not reaching optimum operating temperature it will indeed give you a "check engine light",the code will lean you in that direction as well.The noise your hearing more than likely is coming from the "clutch fan",they are very common on the TrailBlazers to make noise and fail.The oil light... you certainly need to have the oil pressure checked with a mechanical gage.
0helpful
2answers

XV1100 Starter does not engage when trinig to start engin

sorry didn't actually see the post before my first comment, if it is only when the bike is warm or hot but not over heated I would suspect the same thing, faulty starter. "replace or rebuild"
Jul 12, 2013 • Motorcycles
1helpful
1answer

My check engine light is on. Advance Auto Parts says it is the PO 325 Knock Sensor Malfunction Bnk 1 or Single Sensor. My Subaru is a 1996 Impreza. I also have a fast blinking left turn signal that...

  1. Knock sensor. Check all the wiring connections on the engine heads. Your sensor probably is failed (but see Overheating #3 below) .
  2. fast blinking left turn signal. The front bulb has failed, so replace it.
  3. oil temperature light. This may be an indirect result of #1, as the engine is not running properly and this can cause overheating (but see Overheating #3 below)
Other causes of overheating ...
  1. low oil level
  2. low coolant level. If you are losing coolant, the cause has to be located. The correct fill method is to top up the radiator, then repeatedly squeeze the top rad hose, to "burp" all the air out of the cooling system. You will hear the coolant squishing in the top of the engine. Keep burping until the coolant squishing noise stops.
  3. head gasket(s) may be failing, a not uncommon problem for your engine model. Check for oil in the coolant.

SD
0helpful
1answer

OIL LIGHT ON AND OFF AFTER ENGINE WARM UP ENGINE KNOCKS AFTER WARM UP 20W50 OIL IN NOW OIL IS NOT LOW.B WHEN ENGINE IS FIRST STARTED RUNS LIKE A DREAM THEN STARTS MAKING NOISE AND OIL LIGHT COME ON AT IDLE...

First of all , change your oil pressure sender . It should be easy to do and relatively inexpensive. See if that fixes the oil light going on and off. If the light stays on after that , turn off the bike and replace the oil pump. If you have a bad oil pump and continued to drive the bike , you may have caused serious damage to the motor and may end up having to disassemble the engine to determine the cause of the knock.
1helpful
1answer

The engine oil lamp won't go off after ignition key is turned on, and the thing won't start. (i'm guessing the first error indicator is the reason for the second) but.. What is the issue?

Oil light stays on until oil pressure rises enough. Engine temp light should come on when key is turned on and then go off after 3-5 seconds. Wait till temp light goes off and then press starter button but DO NOT open throttle. Bike should start if there are no other problems and oil light should go off after engine starts. If you open throttle, engine may not start.
0helpful
1answer

The engines turns vigorously when I press the Start button, but won't run. There is plenty of fuel, the spark plugs were renewed about 3,500 miles ago [when it was serviced by a n HD dealer]. I have...

If the starter turns the engine over, there's nothing wrong with the starter relay, the solenoid, or the starter. The reason your engine won't run is it has no spark for some reason. I'm afraid that this is all I can tell you. For some reason, the system is not firing the spark plugs. Check the fuse. I hope this helps but I must confess that I don't know a lot about Harley's new electronic system after 2000. I work on the older bike that don't have this system.

Good Luck
Steve
1helpful
2answers

On my 600 diversion oil warning light stays on when starter is pressed, oil and filter just changed so level is spot on could thisbe faulty switch

If it goes out when the engine is running there is no problem.On some models the warning light comes on during start up so you know it works,my car and bike does this to.
2helpful
1answer

Low end knocking 85 V Max 40K miles

Cam chain tensioner if it's knocking 2000-4000RPM under load.
0helpful
1answer

Bike wont start/turnover neutral light goes out when i press starter button oil light stays fully lit. replaced starter solenoid still the same. it was jumped by a car battery. any ideas

Did the starter work when it was jumped by a car battery? If so, the problem is probably the battery in the bike. Take the battery to an automotive parts house and have it tested. Usually, they'll test the battery for free.

What is the CCA of your battery? Those big engines are hard to start and you may not have a battery with enough "Cold Cranking Amps" to turn the engine over. The old Harley Sprint (1973 & '74) was notorious for this. You really had to have a strong battery in that bike for he electric starter to work.

Some bikes have wiring that disables the starter if the transmission is not in neutral. Check on this as well.
0helpful
1answer

Engine knocking on toyota corolla after replacing damaged sump

oil pan and sump damage are very likely to lead to oil distribution problems, this is not temporary, if you hear a knock have it checked by a local mechanic who can verify it for you, it is possible that the engine is damaged internally.
Not finding what you are looking for?

131 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...