Question about 1992 Yamaha FZR 600
Posted by Anonymous on
Really...strange what you need to do is see if the bike is running too fat. So...warm her up witha fresh set of NGK! spark plugs. After the bike is warm take it down the street and back. When your on the way back get on the throttle and accelerate then shut er down and coast it into the garage. This will give an acuurate read on the spark plugs at operating temperature and under a load. Pull all the plugs. If they are brown like coffee with cream that means carbs are adjusted correctly. If they are black and wet too rich and if they are white or very light brown too lean. Other problems may be oil soaked plugs from loose top end parts. Maybe valves or guides.
Posted on Mar 05, 2009
Does the bike have a sidestand switch that cuts the power if the stand is left down? If it does, disconnect it and temporarily join the ends together and try starting....
Posted on Mar 21, 2009
I HAD THE SAME ISSUE. CHECK YOUR VOLTAGE OFF O THE MAGNETO, IT SHOULD BE IN THE 25V RANGE. IF THAT CHECKS OUT OK CK THE VOLTAGE IMEDIATLY AFTER THE VOLTAGE REGULATOR, I BET IT IS BELOW 14V. THE FZR IS PRONE TO HAVING THE REGULATOR GO BAD (THE OLDER ONES HAVE NO COOLING FINS AND THEY BURN THEMSELVES UP). THE BEST ONE TO BUY IS THE NEWER VERSION FROM A 1999 FZR, IT HAS COOLING FINS WHICH GREATLY PROLONGS THE LIFE. YOU HAVE TO DO SOME SLIGHT WIRING MODS, BUT NOTHING ANYONE COULDN'T DO. SEARCH FOR FZR REGULATOR UPGRADE AND IT WILL EXPLAIN EVERYTHING! I HOPE THIS HELPS! GOOD LUCK!
Posted on Mar 22, 2009
Sounds like the bike has been doing wheeles and burnouts. As the clutch plates wear the cable needs adjusting. You have reached the end of the actuating cam. New plates are your best bet.
Posted on Jul 02, 2009
Tips for a great answer:
Jul 02, 2009 | 1992 Yamaha FZR 600
Mar 08, 2015 | 1992 Yamaha FZR 600
52 people viewed this question
Usually answered in minutes!