Question about 2003 Harley Davidson FXDL Dyna Low Rider

1 Answer

2003 FXDL fuel gauge stopped working

Will not work when i put gas in

Posted by Anonymous on

Ad

1 Answer

Gregg Mahin

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Harley Davidson Master
  • 64,934 Answers

Harley Davidson Wiring Diagrams and Schematics
Hi Anonymous, you could have a faulty sending unit or guage, there could be a problem with your wiring. On models with the fuel gauge posing as a left hand fuel cap the gauge is a press fit do not try to unscrew it, simply ample force lift up in a rocking motion to remove gauge. Disconnect wires to the gauge and with a set of positive and negative jumpers from the battery connect the positive jumper and flash the negative, gauge should peg full, if not replace gauge. With a test light check for power to the sending unit, then remove the sending unit and manually operate the float arm slowly with the correct wiring hooked up to the fuel gauge and sending unit and the ignition on, the gauge should respond accordingly if not replace the float arm assembly. For a free wiring diagram please visit the website below and good luck.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Posted on Jun 11, 2015

Ad

1 Related Answer

Joe Hogan

  • 10865 Answers

SOURCE: right blinker on the blink

go to the auto parts store and get a spray can of electronic spray cleaner. Chances are the inside of the bulb holder is glazed and the contact is poor.

Posted on Jul 11, 2009

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed oil and gas filter and spark plug but wont start. wont pick up its gas


put a little gas directly in carburetor and see if it starts with air filter off. if it dose, drain carburetor using screw on bottom of bowel then put more gas in carburetor , and start it and let it run for awhile then put air filter back on. it should work.

May 18, 2015 | Garden

1 Answer

Put bad gas in 2010 colbalt,it womt start now. What should i do?


You are going to have to drain the gas tank and motor of all bad gas. The next time you put gas in it buy some gas treatment and some sea foam and that should clear out the bad gas.

Mar 10, 2015 | 2010 Chevrolet Cobalt

1 Answer

Engin surges on onan tractor moter?


try to turn out high screw on carb half turn if not work try one turn if die put screw were it was restart look for water in gas if dump gas clean carb bowl put in fresh gas new gas try starting if still doing tkea some fuel additive sea foam put that in the gas follow instrutions on can carb should run better will take 2 tank fulls of gas for it to work if that dosnt help rebuild carb

Sep 04, 2014 | Garden

1 Answer

Will not start


If there is an adjusting screw on the carb turn it out a little bit at a time and see if that works before you do anything else. If that don't work put the screw back where you started.
If that doesn't work take the plug out and install a new one and while the plug is out put a table spoon of gas in the spark plug hole and reinstall the plug and put the plug wire back on. If the engine starts but stalls after the little bit of gas is used up. Take the bowl off the carb and clean it out as well as clean the fuel jet that is in the bolt that holds the bowl on. Put back together and see if that works. It is quite often dirty gas that is the problem. Especially if its been sitting. Oh yes put fresh gas in it as well.

Jan 21, 2014 | Yard Machines 24" 208cc Two Stage Snow...

1 Answer

My nephew put the wrong gas inside of it. Weedeatter gas


Drain the gas from the tank and the carburetor put in fresh gas and if it has a bowl drain on the carb leave it open until the fresh gas starts running out. If that doesn't work the carb will likely have to be removed and cleaned.

Jan 19, 2014 | ATVs

3 Answers

I have a 2001 dodge stratus I ran out of gas I put more in and now it will not start


Go put your key in the inigtion turn it to the on position lisen if you can't hear your fuel pump that means it went out due to lack of gas.
you might have to go to the back pf the car by the gas tank so that you can tell if it is working.

Dec 30, 2012 | Cars & Trucks

1 Answer

Drivers door is not working so cant put up window or put gas in car..need to know how to open the gas door so I can put some gas in it to at least use it


If there is an alarm system on your car and its faulty - then open a door with a key. The gas door can be opened with the switch from inside or by pressing on it and it pops out.

Jul 11, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

Ran out of gas put gas in wont start,pulled spark plug and put a little gas in ,it fired but wont stay running,the primmer bulb seems to be not working


Hate to tell you this but if you didn't mix oil with the gas properly (most likely a 40:1 ratio) then the chain saw will seize up and won't work again.

Jun 17, 2011 | Garden

1 Answer

Gas gauge does not work


was the gas tank empty or full some times the gauges won't work untill the tank is full or the wire for the gauge was not put on properly

Aug 18, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

My 2year old toro 6.0 lawn mower wont work i just took it out from the shed, it was in there during the winter and now wont work. it worked perfect before why is this not working someone told me its debris...


did you burn all the gas out at the end of year last year if not bad gas will leave deposits in the carburator.here is a simple sugestion drain any gas out of it thats in it .put fresh gas in it and 2 table spoons of marvel mystery oil in gas tank you can get it at any auto parts store crank it untill you are sure fresh gas oil mixture is in intake wait an hour and let the fresh gas\oil mix do the work.pull plug dip it in fresh gas put plug back in and try to start it this often works if it dont you could have leaves .dirt .rust .or debris on surface of flywheel ,or a bad sheer pin on flywheel the sheer pin is whar times the engine on most small engines good luck i hope these sugestions help

Apr 29, 2009 | Toro Lawn Mower With Toro Power Tools

Not finding what you are looking for?
2003 Harley Davidson FXDL Dyna Low Rider Logo

644 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Mike

Level 3 Expert

4369 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...