Motorcycle over revs without moving throttle after bike runs for about 1 minute it begins to climb in rpm's without moving the throttle if I unplug either ignitor it drops to normal rpm's but has little power @
Running lean on the pilot
Air leak after the carbs
Loose clamps
Stuck throttle cable
Wrongly routed cable
As above with choke
SOURCE: loss of power around 8 -10,000 revs in 3/4 gear
ello m8,,hows things,,clean out the air filter 1st, change all your plugs mr,try that , if nothing u will need to get the carbs balanced to by a bike shop,mechanic,,unless u have carb gauges,,, itl be easier if they do it,, try these 1st m8,, if no joy come back and il go threw step 2 with yuh,,
SOURCE: bike bogs for second then revs when throttling
Pull the slide out of the carb then remove the jet needle and move the clip one notch lower on the needle.
SOURCE: bike bogs when throttling
Quitting is a no-no. Move the needle clip down one notch and also remove and clean the carb if it has been dieing..
SOURCE: CBF1000 - power flat spots in the first 1-2 miles,
Hi, this is a common problem with this bike. After some research I found that it is caused by a valve system to do with the emmissions reduction system on the bike. It does something along the line of pipe exhaust back into the engine or something similar while the bike warms up to reduce emissions, I have read about guys blocking off this hose and apparently this solves the problem. I personally just ride to it, after having the bike for 2 months have learnt this quirk and adjust my riding style to match. If you are still unsure, come to the honda cbf1000 forum. I know I have seen this topic there before with explanations.
SOURCE: the bike idles and runs great at idle but if I rev
the rattle may just be vibration or a failin bearing-old bike--carb shud be takin apart-cleaned-and ajusted if problems get worse--buy a repair manual thats what the pros use
Testimonial: "I will try that...thank you very much!!"
75 views
Usually answered in minutes!
×