SOURCE: i need the torque specs for a 99 GMC sierra k1500
hub to steering knuckle 133 ft lbs.
axle nut 155 ft lbs.
lug nuts 140 ft lbs.
SOURCE: What are front axle nut
Hi In Honda Accord, the torque
for the front axle nut is 181 ft lbs. For the most part, sung it up and then go
a bit further. If you are reusing the old axle nut, tighten it until the stake
mark on the nut lines up with the notch in the axle (make sure to re-stake it).
check out alldata.com/diy for individual vehicle subscriptions which have all
the repair info you will ever need. If you had the steering knuckle out,
tighten the ball joint nuts on the upper and lower control arms until they are
tight and then tighten until the hole lines up to receive the cotter pin.Torque
the axle nuts to exactly 181ft/lbs or to the factory spec. Renting a wrench is
a good idea if you don't think your only going to need to torque something that
high once. Otherwise you can find a decent wrench in auto parts stores or
online, try sears. I'm not sure of the knuckle or wheel bearing design on the
98 but my 94 has a hub over rotor design and the drive axle spline is not
pressed into Please get back to us if
you have further query or else please accept this "particular" solution. Thanks for contacting
fixya.com
SOURCE: What are the stock tire sizes for the front and
Hello,front tire is a 100/90-19 and the rear tire is 170/80-15 those are factory tire sizes
SOURCE: I need to no the torque specs for rocker arm assembly for 95 Honda passport
DYI? recommend a repair manual from your local Auto parts store. You will need it next time, and it handy for reference while you are in the middle of an operation.
463 views
Usually answered in minutes!
×