2005 Harley Davidson FLHTC - FLHTCI Electra Glide classic Logo
jay rock Posted on May 26, 2012

2005 hd flht blows ignition fuse after start up usually 10 to 15 seconds after starting

2 Related Answers

rmprice121

  • 4 Answers
  • Posted on Jan 25, 2009

SOURCE: blows ignition fuse when key is turned on

Look for a grounded wire on the ignition switch or a break in the wiring leading to the fuse. Wiring system on motorcycles are a close system with only the battery being grounded to the frame. Any loose connections or breaks in the wires that will allow the current to jump to the frame with cause you tons of fun.

Ad

Anonymous

  • 420 Answers
  • Posted on Jun 11, 2009

SOURCE: blowing fuses,battery too hot

Sounds like the voltage regulator is not working properly.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2007 3500 HD gas dual 4x4. Why does it keep blowing fuse 58 (ECM/Ignition)?

a short in the ign system or ecm will need a meter to test both systems
1helpful
1answer

2005 Chrysler Town and Country Touring died when put in reverse. Battery is strong. Will not Start. Ignition Fuse blew. Any Ideas?

It looks like you have a short somewhere. You would need to inspect all the wiring related to that in order to pin point the problem. Also check if there is another system working from that same fuse. ie. Power Outlets. Sometimes if they go bad it will blow the fuses shutting down everything else.
I hope this helps!
3helpful
1answer

I keep blowing the accessory fuse on my electra glide

I'd say that you have an intermittant short somewhere. These are very difficult to find. I'd start at the tail light assembly as most of the time, I've found the shorts in that area, from the seat back to the tail light assembly.

Good Luck
Steve
0helpful
2answers

I have a red key light and I have lost my turn signals and brake lights. I have running lights, head lights, cruise, spots and my security is working. The #2 fuse is blown, but when I change it it blows...

Sounds like bad brake light swich/sending unit.The one attached to master cyclinder.What happens to fuse if you turn ign. on,don't start engine,and hit brakes?Should bow fuse if switch is bad.
1helpful
1answer

Sterring lock problem 2005 FLHT Harley Davidson

This is an active recall. Call a dealer, as long as your bike resides in the grouping of bikes, you will get a new ignition switch installed free of charge at no cost to you.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

0helpful
1answer

Blowing fuse

thats usually the sign of a bad injector
0helpful
1answer

Engine Check Light on

I disconnected the battery, pulled the maxi fuse and 15amp ecm fuse. I waited a while and put the fuses back in and connected the battery and it was cleared.
Not finding what you are looking for?

140 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...