Broken kick start
SOURCE: My yamaha pw 80 kickstart
Below is a diagram of the inner part of the kick starter. The spring clip shown is the problem. If it gets weak, it doesn't hold the ratchet gear as snugly as is needed. It is best to install a new clip but often you can just squeeze the clip closed a bit for a better hold to the gear.
Please rate my answer. Thanks!
Testimonial: "thanks for your help"
SOURCE: My yamaha pw 80 won't kickstart and can you tell
I'm assuming you mean gas comes out the spark plug hole with the plug removed??? You probably have a gummed up carburator, due to old gas or dirt. Make sure your air filter is clean first, and then get your carburator thoroughly cleaned. If your float is sticking, or the float needle is dirty or worn out, it will keep dumping fuel to the engine.
SOURCE: kx250 98model low pressure on kickstart
complete cylinder compression test. should be approx 120 psi
if low you will have to replace piston rings.
was bike running good before?
961 views
Usually answered in minutes!
×