Does anyone know how to remove the tank on a 2011 wide glide ? I am putting on a set of auxiliary lights, and then a have to remove the tank because of the wiring.

Duplicate question already answered

Hi, Mike and the usual suspects are:
1. Throttle cables not properly adjusted.
2. Idle screw adjusted too low.
3. Air-fuel mixture screws not properly adjusted.
4. Pilot jet clogged.
5. Pilot jets too small.
6. Clogged air filter.
7. Faulty choke.
8. Multi carburetors not in sync.
9. Carburetor float needle valve stuck.
10. Fuel not getting to the carburetor.
11. Slide stuck in the carburetor.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected]. Good luck and have a wonderful day.
https://www.hdforums.com/forum/dyna-glide-models/1129387-2011-wide-glide-is-dying-at-idle.html
http://www.mediafire.com/file/g3h2vn0nvw3b5wb/2001_Harley_Dyna_Service_Manual.pdf/file
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/harley-davidson-dyna-glide-owners-manuals/
https://www.6ya.com/how-6ya-works to speak to me personally.

The engine oil drain plug is on the left side of the oil tank at the rear of the oil tank where the jiffy stand rests when it is in the up poisition.

disconnect hose at tanks petcock, replace with a longer hose to drain gas into gas can, turn petcock on & let it drain until empty

Release the fuel quick disconnect on the left side under the tank. Unplug the wires for the fuel sending unit. Remove both bolts on each side at the front of the tank. Remove the seat and remove the bolt at the rear of the tank. Lift the tank off.

Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.youtube.com/watch?v=iWNQhPfMW4k
http://www.mediafire.com/file/u6rd3qqr73d2qug/2011_Harley_Dyna_Service_Manual.pdf
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
https://ownersmanuals2.com/harley-davidson/wide-glide-2011-owners-manual-66669
https://www.6ya.com/how-6ya-works to speak to me personally.

Hi, Joe tail light issues are relatively easy to diagnose and repair always check the tail light fuse first and make sure you have power on both sides of the fuse holder and the usual suspects are:
1. Taillight bulb element is broken.
2. Taillight bulb soldered contacts are extremely worn down.
3. Taillight bulb socket corroded.
4. Taillight bulb socket has no power and or ground.
5. Taillight wiring harness damaged from the rear tire.
6. Taillight rear fender wiring harness connector faulty due to corroded, broken, or loose pins/sockets.
For more information about your issue and valuable "FREE" downloads that you need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected]. Good luck and have a wonderful day.
https://www.hdforums.com/forum/sportster-models/620758-tail-light-not-working.html
http://www.mediafire.com/file/u6rd3qqr73d2qug/2011_Harley_Dyna_Service_Manual.pdf
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
https://ownersmanuals2.com/harley-davidson/wide-glide-2011-owners-manual-66669
https://www.6ya.com/how-6ya-works to speak to me personally.

Remove the seat, disconnect the fuel line, remove the front fuel tank fastener(s) and the rear fuel tank fastener, if you had a console you would also remove this to get underneath it to disconnect wires etc under it.

not running for a year! You have a varnish buildup in the low end circuit of the carb. You will need to remove the carb and do a full teardown of the carb to properly rectify this problem. SOMETIMES we are able to free up the passages by putting SEA FOAM cleaner in the tank , fill her up with fresh fuel and ride through the tank and it will clear up. SEA FOAM can be purchased at an auto parts store and is sometimes very effective. 1/4 cup to full tank fuel.