1986 Honda GL1200 Goldwing SEI fuel system light stays on

SOURCE: 1986 sei 1200 goldwing It

check the fuel filter it sounds like it's pluged and causing too much back presure this is causing an over load in the fuel pump causing it to stop working or to presure lock

SOURCE: 1986 honda gl1200 sei seems

I would get a load test done on the battery.....Hope this helps.

SOURCE: i have 2 questions first of all where is the fuel

Hello,

I see that your question hasn't been answered in six months. I was doing a search on users that are having problems with Gold Wings and came across your questions. The following information should be helpful.

The Fuel Pressure Regulator is located is attached to the rear end of the right-hand fuel delivery pipe.

You can locate the fuel filter by doing the following:

1. Remove the seat by lifting it straight up and away from the frame. Locate the fuel lines where they go into the gas tank. Follow the fuel lines until they go into the filter. The filter will be located between the fuel pump and the gas tank.
   
2. Unbolt the filter from the mounting bracket with a socket and a ratchet. Pull the filter away from where it is mounted to the bracket to allow better access to the fuel lines.
   
3. Loosen the hose clamps that hold the fuel filter on with a screwdriver. Pull the fuel lines off of the fuel filter. If the fuel lines are held on with a quick connect fitting, lift the tab on the fitting with a flat head screwdriver and pull the fuel lines off of the filter.
   
4. Install the new filter in the same orientation as the old one. Ensure that the arrow on the filter is pointing towards the fuel pump.
   
5. Slide the fuel lines onto the new fuel filter. Tighten the hose clamps with a Phillips screwdriver or slide them on until they clip into place if they are the quick connect style.