Question about 1989 Yamaha FZR 600

Open Question

Where do i download a free 1989 yamahafzr 600 service manual

Need a full service manual for my 1989 yamaha fzr 600

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 28 Answers

SOURCE: 1994 Yamaha fzr 600 speedometer not working.

speed odometer cable needs to be replaced

Posted on Dec 28, 2008


Anonymous

  • 3 Answers

SOURCE: 1994 yamaha fzr 600 spark plugs foul after about

Really...strange what you need to do is see if the bike is running too fat. So...warm her up witha fresh set of NGK! spark plugs. After the bike is warm take it down the street and back. When your on the way back get on the throttle and accelerate then shut er down and coast it into the garage. This will give an acuurate read on the spark plugs at operating temperature and under a load. Pull all the plugs. If they are brown like coffee with cream that means carbs are adjusted correctly. If they are black and wet too rich and if they are white or very light brown too lean. Other problems may be oil soaked plugs from loose top end parts. Maybe valves or guides.

Posted on Mar 05, 2009

Ad

tombones

  • 3567 Answers

SOURCE: my 1991 yamaha fzr 600 has been sitting for three

Any water in the gas? Remove the water trap bowl at the bottom of the petcock, (gas valve). Any water or trash in the bowl? ( not all bikes have a water trap bowl ). Drain all the old gas from the tank. Install an in-line fuel filter. You will need to clean the built up varnish from the evaporated gas out of the carbs.

FOR EACH carb > Remove the float bowl and clean the entire
carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray all the little airways and fittings in the carb. Remove the two screws on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. Balance and sync the carbs.

I strongly suggest you to let the shop take care of the carbs. Cleaning can be a nightmare times four and doing the balancing and sync of the carbs sounds easier than it is. If you do the carb work then be sure you have a fire extinguisher at hand. I am serious about that.

Please rate this solution. Thanks!

Posted on Mar 29, 2009

Moto-Wiz

Moto-Wiz

  • 34 Answers

SOURCE: 94 yamaha fzr 600. only firing on 1 an 2 cyl

No one thing controls those items.
The ignition and headlight circuits
each have their own fuses under the seat.

If you have power to both of the coil sets
then the coil for cylinder 3 and 4
might be faulty.

Lights may just have a blown fuse.

You have more than one problem
going on there.

Posted on Aug 21, 2009

voodoomox

marlon john madrid

  • 1689 Answers

SOURCE: yamaha tw200 service manual

here's one from ADV rider:

http://www.advrider.com/forums/showthread.php?t=325164

and ads somewhere:

http://www.tradebit.com/filedetail.php/6421300-yamaha-01-09-trailway-tw200-service-manual-pdf

Posted on Sep 09, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...
1989 Yamaha FZR 600 Logo

Related Topics:

480 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

gbob59

Level 3 Expert

3063 Answers

randymanfive

Level 3 Expert

501 Answers

Cindy Wells

Level 3 Expert

6198 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...