SOURCE: can you direct me to instructions on how to change
need torque specs on head and gappingfor valves for a triumph tiger 650 1970s
SOURCE: how do i change the oil on a 2002 harley road
This is lotsa of fun. First you have 2 bolts, one is at the front of your oil pan the other more towards the rear. the front one is your engine oil the rear one your tranny oil.
First remove or loosen the oil dipstick from the bike. next while on flat ground or on a lift remove the fron screw (it uses a socket or an allen?) use a socket. Drain oil, next comes the messy part. The oil filter is obstructed a little bit by your crank position sensor (CPS) Harley has an oil filter wrench that takes this into account. Lossen the filter about a half to three quarters turn at least. Here is what I do to try to avoid a mess, I take and use to plastic bags from the grocery store, one inside the other. I then basicall try and bag the filter. with the bags on and drip pan below I loosen the filter through the bags until it comes off. There are all sorts of guards you can buy to try and help with the mess, I just haven't had any luck with them. Once you get thefilter out use a lint free rag like an old T-shirt to get any remaining oil off the oil filter housing. Now take a couple drops of new oil, I like to use the Amsoil 10-40 motorcyle oil personally, and smear throughly on the O-ring on the new oil filter, hand tighten the new filter back on. Then using the oil filter wrench of choice tighten it a quarter turn or so. DO NOT OVER TIGHTEN, makes for a really BAD day. Now go back under the bike and put the plug back in, if you need to clean up use a brake cleaner that will not harm paint (DO NOT SMOKE AROUND THIS STUFF). Since you have replaced the filter you are going to need 4 quarts of oil. Once oil is in place filler cap back on start the bike and do not worry the oil pressure light will come on then flicker than go off, all this happens in 5 seconds or less. Inspect the plug and filter to make sure there are no leaks and you are ready to go.
JP
SOURCE: How many ounces does a 2008 FLHR Harley Davidson Road King hold?
Well i blow about 20 ounces of fluid and u ?
I guess you are talking about fork oil? it's measured!!!
SOURCE: oil change procedure 2000 road king
the oil tank is on the bottom of the transmission in your RK. There are two drain plugs. The plug towards the front left of the pan is the oil drain plug. The other one is for the transmission.
Drain the oil, replace the filter, refill with three quarts of oil and you're ready to go. The dipstick has two marks on it. The upper mark is "FULL HOT", and the lower mark is "FULL COLD". Do not overfill.
Don't forget to service the transmission and the primary at their recommended intervals.
Good Luck
steve
695 views
Usually answered in minutes!
×