Turn on goes to fuel and stays there replaced gauge does same thing
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: fuse box
Looking at the bike from the front, it is located under the side cover, on the right hand side, you we need remove saddle bag. Once removed the fuse box is located under the plastic cover.
SOURCE: adjust clutch cable
If you have a stock cable you need a 9/16 and a 1/2 in. wrench. about 1/2 way downn the cable there is a rubber boot. pull the rubber boot over the adjustment. Loosen the liock nut and adjust the cable so you have aprox 1/8 to 1/16 in. slack in the handle. Re tighten the lock nut and pull the rubber back over the adjustment.
SOURCE: How do I change the front and rear brakes on a
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
SOURCE: no oil pressure for my 2005 Harley-Davidson Ultra
camplate check valve sticking,good time for an upgrade SEcamplate,hydraulic camchain tensioners,high volume oil pump,comes as complete kit for about $420. add another $150 for adjustable pushrods and never worry about it again,or replace the existing component youd save maybe $180 bucks but youll be back
thats why they changed the camplate and tensioners in 07, I just did the complete conversion on an 02 heritage it costed with labor about 1100 in your case your looking at 7 to 800 dollars just to get you going for another 30 or 40,000 miles or less and then do it again Im for a 1 time fix myself
500 views
Usually answered in minutes!
×