What's your problem?1995 yamaha virago 1100 that sometimes you you put into gear and immediately dies

Question edited for clarity.
Please don't type in all CAPS, it is considered SHOUTING and harder to read.
Question moved to model category.

It is a badly adjusted clutch, or the switch on the kickstand.

https://www.google.com/search?q=2006+YAMAHA+V+STAR+1100+engine+dies+when+you+put+into+gear

..

You have clogged pilot jets in the carbs.

This is more of I have the same problem starts up good runs good in neutral but as soon as I pull cluc5h an shot into first or any gear it stalls out also wont start in any gear even with clutch pulled it dies every time. Put it to neutral an it atarya up runs but dies whenever I they to shift so please someone help i miss riding my bike 2004 Yamaha v star 650 classic

Yamaha motorcycles of this vintage often have issues with their kickstand switch. This switch can be disabled by clipping the two wires that go into the switch and wiring them together--the kickstand switch is normally closed (letting current flow) when the stand is up; the switch is open when the kickstand is down.
This is more afield than your electrical concerns, but if the clutch plates have bonded together, the bike will stall when you put the bike into gear. The bike will start and idle fine, but basically, you don't have a working clutch, so the bike will stall out when you dump it into gear while at a standstill. You can test for this by starting the bike and having someone push the bike to get up to a little speed, then trying to shift into 2nd gear. If the bike lurches forward before stalling or keeps running, you have a clutch, not an electrical issue.
Folks sometimes get lucky, and working the clutch plates a few times will free up the sticking plates. I have had this problem with a mid-1970s vintage Honda that I don't ride very often. Eventually, the clutch plates free up and the bike is good to ride again.
Good luck!

i think you have to adjust the clutch cable play to specs of the bike or your clutch plates needs replacement.

Check your kickstand switch. It will not allow the engine to run in gear when you release the clutch lever. It may be gummed up.

I would seriouly look at the starter clutch, the 1100 yamaha cruiser motors are notorious for this problem way back when the same motor was in the viragos and the xvs 1100 vstars, yamaha have tried to fix the prob over the years but stillhavn't got it right. if it just spins and whirs without engaging the engine, but sometime will kick in engagement, it sounds like your starter clutch is on it's way out. they cost from yamaha around $450- 500 ea plus around $350 to fit you have to include a $30 gasket in all that.