2000 Yamaha V Star 1100 Custom Logo

Related Topics:

A
Anonymous Posted on Nov 08, 2011

My 2000 yamaha vstar 1100 custom runs good but has a rattling noise in the front cylinder what could be the noise is it hard to fix or expensive

5 Related Answers

Anonymous

  • 292 Answers
  • Posted on Apr 04, 2009

SOURCE: 1999 Yamaha Vstar 650 Custom ...makes clicking noise when trned

i use a jump box on mine most weekends when i wanna take it out, i hook the red to battery and black onto my exhaust and it fires right up no problem. is the clicking noise coming from the fuel pump behind the ignition? it should click for a few seconds then stop. if it stays on then you are not getting enough fuel outta the tank, change the fuel filter and if bike had been stored for winter get a good fuel system cleaner, additive type. if in USA get Berrymans B12, double dose get bike to run hopefully let it stand overnight and all should be fine. fingers crossed. if is is clicking from somewhere else like starter or a relay by the battery, check all the ground terminals you can find
http://www.carlsalter.com/aaman/Yamaha_VSTAR_650_MAIN_MAN.pdf
thats a link for a free pdf service manual
5bead5b.jpg my 99 v star

Ad

Anonymous

  • 1689 Answers
  • Posted on May 04, 2009

SOURCE: finding the battery on a vstar 1100 custom for dummies

hi dm09diver

the link below will show you where the battery is seated and how it is attached.

please click on the link below and go to page 33

http://www.yamaha-motor.com.mx/Manual_Partes/Catalogos/Deportivas%20(Crucero)/XVS1100%20V%20Star/5YST_2007.pdf

hope this helps,

regards

voodoo

Anonymous

  • 1 Answer
  • Posted on May 31, 2009

SOURCE: Is there a free online manual for a 2000 Yamaha

I have found a sight that has all kind of Q&As and has been very heplful. www.sloneservices.com and go to knowledge base. Hope it helps.

Anonymous

  • 22 Answers
  • Posted on Jul 08, 2009

SOURCE: 2000 yamaha vstar 1100 custom. starter problem?

I had the same problem 2001 XVS1100 Custom
this is a starter issue Over time the starter on this bike twists when its under a load.
Look at the two bolts holding the starter on if they are not straight across then its twisted. turn starter back in line with a pair of big channel locks and try to start this should do the trick if this works i would recommend taking the two bolts out and bend them back straight or replace and reinstall starter this should fixya problem

Hope this helps ...............Jimmyfixya

swDemonDog

  • 233 Answers
  • Posted on Oct 07, 2009

SOURCE: 2002 Yamaha Vstar 1100 Custom. STARTER Problem

The starter button is used in an open circuit design.
You must press the starter button to "Close" this circuit before the starter will engage. Taking the starter button out of the loop helps support the suspect short. Assuming you kept the starter button wires from touching. :) If not, it is most likely the starter button.

Trace the wires coming from the starter button.
There could be a short circuit. (Same as pushing the starter button). Check along the handle bars and anywhere rubbing could cause a break in the insulation. Try this at night with the lights off.
You may be able to SEE the spark and locate it quickly.

Good luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Front cylinder not firing and back fires.have cleaned carbs reset float ect...,

Greg o day YOU DA MAN you also helped me with my 2001 vstar 1100 i was having same trouble with coils i tested the ohms ,voltage and spark every thing looked good but was still not running on front cylinder until i replaced the coils.
1helpful
2answers

Motorcycle running on one cylinder

First, determine which cylinder is bad. Touch the exhaust pipes to determine which is hotter.(the pipes get VERY hot so be quick or use a non-contact thermometer.)
Remove and look at the bad cylinder's plug, if ti's wet you are getting fuel, try replacing it. (Heck, replace it anyway.)
If there is no fuel on the plug the carburetor might be plugged or need cleaning.
Not finding what you are looking for?

89 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...