SOURCE: Stored settings and auto eject
Hi Factus, Ampman is right about the two power sources. I wish to add that the you should check to see that the yellow wire is powered. You may want to run another yellow wire from the 12V always on terminal on your fuse block to the radio. This will eliminate any possiblilty of a problem in the wire between the radio and power source. The Red wire is powered only when the key is turned on.
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: fuse box
Looking at the bike from the front, it is located under the side cover, on the right hand side, you we need remove saddle bag. Once removed the fuse box is located under the plastic cover.
SOURCE: adjust clutch cable
If you have a stock cable you need a 9/16 and a 1/2 in. wrench. about 1/2 way downn the cable there is a rubber boot. pull the rubber boot over the adjustment. Loosen the liock nut and adjust the cable so you have aprox 1/8 to 1/16 in. slack in the handle. Re tighten the lock nut and pull the rubber back over the adjustment.
184 views
Usually answered in minutes!
×