Question about 2008 Xispa Xy260T4

1 Answer

Cut out 2008 Xispa Xy260T4

My xy260t4 scooter just cut off and now won't start. It has 1000 miles on it and was running great. @

Posted by wthuck on

Ad

1 Answer

Gregg Mahin

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Xispa Master
  • 61,850 Answers

Hi, Wthuck and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. A failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Faulty or corroded kill switch.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen the gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from the intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.bikechatforums.com/viewtopic.php?t=204114
http://scootdawg.proboards.com/thread/28174/scooter-stalling-cutting-out
http://lncrgen.nation2.com/xy260t-4-scooter-service-manual
http://www.family-motorsports.net/GY6-50cc-150cc.pdf
http://www.genuinemotorcycleparts.com/parts/Xispa/XY260T-4/
https://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

Posted on Jan 02, 2020

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Sym moped starts but won't idle It shuts off when trying to give it gas


Hi, Gigi and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Float needle and seat sticking.
5. Float level too low.
6. Carburetor bowl vent line clogged/blocked/pinched.
7. Idle adjusting screw set too low.
8. Air/fuel mixture screw set too lean.
9. Idle port, transfer ports, slow air jet clogged.
10. Slow fuel jet clogged.
11. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the links below. Good luck and have a nice day.
Scooter Questions Get Answers to Your Scooter Starting Question
Scooter Troubleshooting Scooter won run All about Scooters
My chinese scooter wont idle or start Check the fuel petcock
http://scooterunderground.ca/knowledge/manuals/documents/sym_fiddleii125_service_manual.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Oct 01, 2016 | Sym 125 EXC SIXDAyS Motorcycles

1 Answer

Scoot runs and drives fine but will not turn off by ignition


Hi, Zak you may have a faulty ignition switch for more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day. Scooter won turn off
how to fix gy6 Scooter wont turn off kill switch not working Great Prank...
GY6 Scooter wont turn off kill switch not working Great Prank Keeps...
http://www.apriliaforum.com/forums/showthread.php?227549-2001-SR50-Won-t-shut-off

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e



Apr 02, 2016 | Motorcycles

1 Answer

Strating PROBLEM


Hi, Andrew and the usual suspects are:
1. Fuel cap or fuel tank is not venting properly.
2. Fuel filter clogged.
3. Fuel line pinched or kinked.
4. Vacuum line from the petcock to intake manifold cracked.
5. Float needle and seat sticking.
6. Float level too low.
7. Carburetor bowl vent line clogged/blocked/pinched.
8. Idle adjusting screw set too low.
9. Air/fuel mixture screw set too lean.
10. Idle port, transfer ports, slow air jet clogged.
11. Slow fuel jet clogged.
12. Faulty fuel pump.
For more information about your issue and valuable "Free" downloads that you will need please Click on the blue links below. Good luck and have a wonderful day.
Why won my SYM Jet motor scooter start
Scooter Troubleshooting Scooter won start All about Scooters
Sym Jet 50 Service Manual
SYM Sanyang Scooter Parts Racing Planet USA
Sym JET 50 series Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

May 09, 2017 | 2007 Sym Jet Euro X 50

1 Answer

Hi, I have a Xingyue XY260T-4 that w,on't start. It was running great when I first got it, it had about 3800 miles, then it suddenly started bogging down past 3000 RPM without warning, then stopped...


IT'S FLOODED, CHANGE YOUR OIL' TAKE THE PLUGS OUT SPIN IT OVER A FEW TIMES THEN SQIRT SOME OIL DOWN THE PLUG HOLES, SPIN IT AGAIN THEN THROW YOUR PLUGS IN, IT SHOULD START, IT WILL SMOKE A LITTLE FOR 10 OR 15 MINUTES BUT IT WILL STOP. GOOD LUCK!

Jul 28, 2011 | 2011 Xingyue Xy260T4

1 Answer

I have a xingyue xy260t-4 with 2000 miles on it. I am having a couple problems. The first is the fuel gauge reads empty most of the time. Sometimes it will go to half. Any idea what might be wrong? Next is...


My scooter dose the same with the gas gauge it seem to be the reading gauge in the tank if you fill it up and ride it for about 40 miles you will see the gauge go up to full as the gas starts to go down.

Jul 17, 2011 | 2011 Xingyue Xy260T4

1 Answer

Rover 75 v6 starts no problem runs 1000 rpm then


check idle speed sensor on your intake manifold around 700 to 750 rpm is normal ,air temp may efect idle speed .

Sep 17, 2009 | 1999 BMW 323 Series

Not finding what you are looking for?
2008 Xispa Xy260T4 Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Xispa Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6347 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Xispa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...