Red Motorcycles - Recent Questions, Troubleshooting & Support


Lots of ideas in the GSXR Forums Eric.

FI light on. Too much oil???? ' Suzuki GSX-R Motorcycle Forums ...


https://www.gixxer.com > ... > 06-07 GSX-R600/750

Apr 16, 2008 - ... oil in a 06 gsxr 600/750 it will cause the right light to stay on and "FI" symbol ... I just an 06 750 yesterday and after riding the bike home if noticed the red light was on .... in the case the red light comes on and the oil symbol is blinking. ... As you look at it, start the engine, you should see oil moving around. F1 Code
Oct. 1, 2009
F1 light blinking
Jul. 11, 2007
Blinkin FI light??? BIke wont start! ANY HELP??
Jan. 8, 2008
FI light and bike dying
May 2, 2016
More results from www.gixxer.com

Red light, FI light, chec light - GSXR.com


https://www.gsxr.com > 7-general-gsxr-chat > 178201-red-light-fi-light-ch...

Jun 10, 2018 - It is always on when the bike is not running as it also triggered by low oil pressure. No run = no oil pressure. Normal. If the red light is on AND you have a flashing "FI" in the temp window then you have a code. FI (F1?) red light on dash
Jun. 17, 2007
F1 Light On Gsxr 750k7
Jun. 7, 2018
Red light and F1 flashing on cluster
Jun. 10, 2018
"5d" or "Sd" ERROR ??
Jun. 7, 2018
More results from www.gsxr.com

Red Motorcycles | Answered on Dec 03, 2019


Inside the cylinders there is a fire when the engine is running and the exhaust gasses coming out heat up the metal. If this is a homemade dirt bike make the exhaust pipe routed away from you as much as possible and add a guard around the outside of the pipe.

Red Motorcycles | Answered on Sep 24, 2019


the red key has to do with security.. if you have a remote control for your security alarm you may need to change the batteries

Red Motorcycles | Answered on Apr 25, 2019


Sounds like you have a Lifan 50cc motor to begin with. The loose and disconnected wires are more of a concern to me and without enough information to properly answer the question my suggestion would first to isolate those loose connections by applying electrical tape so that those wires that are exposed so that they do not ground out and short out the CDI, it is very possible that you may have damaged your CDI which is the Computer that controls the motor, spark and other electrical components on the motorcycle itself. Fortunately the CDI’s for Lifan engines can be easily and cheaply sourced on eBay or Amazon but be sure to choose wisely— there are many out there so pay attention to part numbers which may be stamped on the CDI. As For finding an electrical schematic that is going to be a far more difficult task and quite frankly may not be necessary in your case I would start with first taking care of those loose wires followed by checking and or replacing your CDI and see what that will get you. Be sure your battery is properly load tested and charged and GROUNDED properly

Red Motorcycles | Answered on Mar 31, 2019


Check fuel mix for being too lean. It will run hotter. If you are caning it around, they will glow.

Red Motorcycles | Answered on Mar 22, 2019


SERVICE REMINDER LIGHT
When the service reminder light lights up or
blinks, this will indicate that the cut-out
carbon brushes will switch off the tool in
approximately 8 hours. After that period, the
light will go off and the tool will stop running.
The tool must then be sent to a service
center for service

Bosch 11316evs Operating safety Instructions Manual Page 9

Red Motorcycles | Answered on Jan 24, 2019


Exhaust pipes too hot? Engine running too lean. Adjust carb to make richer...more fuel, less air

Red Motorcycles | Answered on Nov 13, 2018


Hi, Corrie, I answer motorcycle questions on Fixya which is a free Q&A site about nonmedical everyday things and I find extremely disturbing that you would choose this website for a medical emergency about your 17-month old son instead of calling 911, your doctor, or the hospital. I do not know what country you live in and maybe you are not close to medical services. If his breathing is O.K. then just stay by his side and monitor his progress. If he gets worse then seek immediate medical attention. Good luck and may the Holy Spirit watch over you and your son.

Red Motorcycles | Answered on Sep 15, 2018


possible be the light wire to read it at night
look for a light power wire

Red Motorcycles | Answered on Sep 11, 2018


Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Skyjet, despair not, for a mere $20 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Skyjet 125 wiring diagram Google Search
http://www.mychinamoto.com/forums/showthread.php?5648-wiring-diagram-full
Skyjet Motorcycle repair manuals $20
https://www.chinesemotorcyclepartsonline.co.uk/manufacturer/Skyjet
http://absolutelyscooters.net/pdf/CGEN_dawg_scooter_manual.pdf

Red Motorcycles | Answered on Sep 10, 2018


*Tailpipe

A weak mixture normally. Which also damages spark plugs, valves on a four stroke and piston crowns. Tailpipes and mufflers do get hot though.

Red Motorcycles | Answered on Jun 24, 2018


You probably cant, most modern carbs are factory set for optimal performance v fuel economy, the only adjustment you may be able to make is the idle speed setting

Red Motorcycles | Answered on Jun 20, 2018


red hot exhausts indicate
ignition timing late
valve timing incorrect
red hot occurs when the exhaust valve opens and allows burning compression gasses into the exhaust system (500-600C) instead of the cooler burnt mixture
If you have an EGR system then that system is faulty and not bypassing exhaust into the inlet to cool the combustion temperature

Red Motorcycles | Answered on May 04, 2018


Have you checked the owners manual to see what can cause the bike to stop. It sound very much like the cut out switch to the side stand or clutch is faulty and is causing the engine to stop.

Red Motorcycles | Answered on Jan 03, 2018


Check oil level, and look for leaks under the car you might have a bad engine main seal that contaminated the clutch.

Red Motorcycles | Answered on Oct 27, 2017

Not finding what you are looking for?
Red Logo

66 questions posted

Ask a Question

Usually answered in minutes!

Top Red Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Pcm2048

Level 3 Expert

753 Answers

David Gust

Level 2 Expert

173 Answers

Are you a Red Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...