20 Most Recent 1993 Yamaha XV 535 Virago DX - Page 2 Questions & Answers


The pilot jet controls the air/gas fuel mix at idle . If the jet gets plugged up not enough gas gets to the emgine at idle. You will need to remove the carbs and float bowls and clean them, paying special attention to the pilot valve. Count the number of turns to remove the pilot screw and replace the same number of turns then turn counter clockwise 1/2 turn.

A “very helpful” rating for this answer? Thanks!

9b78257.gif

1993 Yamaha XV... | Answered on Aug 11, 2014


check for fuel to the rear cylinder. ( dirty carb)

1993 Yamaha XV... | Answered on Aug 03, 2013


ok you can go to a local dealership or go to a bike salvage yard you can also get some wire and replace them your self by splicing them in to the conectors i sugest a local bike salvage yard

1993 Yamaha XV... | Answered on Feb 19, 2013


The fuse box is located under the seat of the bike near the fuel filter it should be the 10A fuse next to the Main fuse (the 30A). if the fuse is ok and the high beam works, it sounds like there is a issue with the low beam wire. If that is the case then the lamp plug should have 3 wires on the back, yellow for High beam, green for Low beam, and black for Ground. then start test the green wire to see if you have power, if not at the plug then check at the dimmer switch, if not there then the start switch. 89_96_us_xv535.jpg

1993 Yamaha XV... | Answered on Jul 24, 2012


a clymer manual shows procedure--paint remover or a carb solution will rid the varnish--the stuf in cans for dollar doesnt work--u need to take carbs off and soak them--library has cycle books too

1993 Yamaha XV... | Answered on Mar 12, 2012


I wouldn't expect that a week sitting would have any significant effect of it starting. However if the climate you are in is very hot and dry then it's possible that the fuel in the carburetor(s) has evaporated. Also if the battery is weak you may be using all available power to crank the engine over with the electric start leaving less then 10 volts for the ignition system which will not work under that voltage. SO there are two possibles here, first make sure the battery is fully charged try it again if it doesn't start then the greater possibility lies in the carburetor. Tapping the carburetor lightly with a small metal object like the handle end of a ratchet wrench or the hard plastic end of a screwdriver may dislodge the float and allow fuel to flow into the float bowl area and fill the carburetor and allow it to start. If you are in a cold climate with a temperature around 50F (10c) then the motorcycle may need to use the choke heavier and also the battery will produce less power when cold. Charge the battery and use the choke heavier. Cold weather and motorcycles don't play well together.

1993 Yamaha XV... | Answered on Dec 17, 2010


If the engine stroke and the diamaiter of the ends of the crank are the same then is will as long as it fixs on and has same # of cylinders

1993 Yamaha XV... | Answered on Dec 17, 2010


http://www.totalmotorcycle.com/maintenance/sparkplugs.htm

1993 Yamaha XV... | Answered on May 26, 2010


faulty starter motor or bad battery connection

1993 Yamaha XV... | Answered on Mar 03, 2010


if u want an easier way go to the dealer with ur paperwork 4 the bike and ask for a key code and just get one cut. it cost me $30

1993 Yamaha XV... | Answered on Nov 20, 2009


You can download a Virago manual from here:

http://www.viragotech.com/

1993 Yamaha XV... | Answered on Sep 05, 2009


your bikes power specification is
Horsepower 45 [email protected] Torque 33 ft [email protected],000rpm
as found at http://vocpics.com/XV-535.htm

1993 Yamaha XV... | Answered on Aug 17, 2009


Sounds like a fueling problem either water in the carbs or the fuel flow from the tap is insufficient. If there is a vacuum pipe it may have been dislodged or holed.
Ride Safe
Bike-Doc

Please mark this as useful (if it has been!!)

1993 Yamaha XV... | Answered on Aug 03, 2009


ALWAYS have a fire extinguisher on hand when working on carburetors.
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).

Drain the carburetor. There should be a screw on the lower side of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.

Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the
carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Before putting the slide back in the throat of the carb, move the clip on the jet needle one notch lower. Put the rest of the
carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.

Please rate this solution. Thanks!

1993 Yamaha XV... | Answered on Jun 13, 2009


kindly refer to this article will help you alot
http://faq.f650.com/FAQs/HardStartingPoorRunningFAQ.htm
happy biking!!!!!!!!!

1993 Yamaha XV... | Answered on May 08, 2009


****, squeeze, bang, blow... check filter, fuel and spark... its going to be prob a fuel problem. if the bike hasnt been running all winter run some gumout through it... and get rid of the fuel thats been sitting in the tank. more info would help but it sounds like you got varnish in your carb....

1993 Yamaha XV... | Answered on May 02, 2009


There are seals inside the petcock which have perished. They need replacing or go to a breakers and get a second hand one.

1993 Yamaha XV... | Answered on Apr 05, 2009


you can get clymer manual for 35.00

1993 Yamaha XV... | Answered on Feb 25, 2009

Not finding what you are looking for?
1993 Yamaha XV 535 Virago DX Logo

Popular Tags

41 questions posted

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

gbob59

Level 3 Expert

3063 Answers

randymanfive

Level 3 Expert

501 Answers

Cindy Wells

Level 3 Expert

6220 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

XV 535 Virago DX Yamaha

  • XV 535 Virago DX Yamaha

Most Popular Question

1993 yamaha xv535 headlight issue

  • Motorcycles
Loading...