20 Most Recent 2008 Triumph Thruxton 900 Questions & Answers

You will need to change main jets and adjust carbs because of the back pressure change. Make sure the straight pipes are at least 24 inches long past the head connections or you can burn your valves.

Check your coils and plugs. Both of these can break down when exposed to heat. It can sometimes cause a circuit to open when it expands with heat , and close again when it all cools.

not enough info, does it seem like it too hot, what color are your plugs.

If your steering head is tight, with no play, like I'm willing to bet it is then look at the front tire. The tread blocks should be smooth to the touch. Turning a bike puts a lateral wear on the tires and makes the tread blocks wear with uneven hieghts. Even the slightest uneven wear willl cause a head shake when the road and speed provide the right conditions.

https://www.triumphrat.net/club-cafe/14974-thruxton-tire-pressure.html

Dont you just hate the intermitent faults? However messing with the ignition should have no bearing on the fault, other than the connection plate inside the switch has become corroded or worn away, have you removed or replaced the switch? Ifyou remove the switch and dismantle the base carefully to check for ware or corrosion, this can normaly be repaired by using a file or some heavy sandpaper to clean the contact plate, igniter units either work or they dont,

You need a tool that goes down the inside of the fork tube to hold the inside. Unless you use an air ratchet which may undo it.
I decided that it was less hassle to get someone else to do that!

Good Luck

Parts Suppliers. The normal thing to think is "I'll just bypass them", but the tip over sensor cuts power to the engine if you drop the bike riding it. https://www.google.com/search?q=2001+Triumph+600TT+kickstand+and+tip+over+sensor ..

https://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=&cad=rja&uact=8&ved=2ahUKEwj1rfLS9vL-AhXFATQIHSEjDGMQFnoECBwQAQ&url=https%3A%2F%2Fwww.fixya.com%2Fmotorcycles%2Ft20960514-went_start_triumph_tiger_1050_as&usg=AOvVaw0JsHR2CItbYHI-nBz7GaK8

There are several possible reasons why the battery on your 1997 Triumph Daytona 955i may not be charging while you are riding it:

1. The battery may be faulty. If the battery is not holding a charge or is not functioning properly, it will not be able to charge while you are riding the motorcycle.
2. The charging system may malfunction. The charging system is responsible for supplying power to the battery while the motorcycle is running. If the charging system is not functioning properly, the battery will not be able to charge.
3. The voltage regulator may be malfunctioning. The voltage regulator is a component of the charging system that regulates the voltage supplied to the battery. If the voltage regulator is not functioning properly, the battery may not be able to charge.
4. The battery cables or connections may be loose or damaged. If the battery cables or connections are loose or damaged, the battery will not be able to receive a charge.

To troubleshoot the problem, you should start by checking the battery to see if it is functioning properly. If the battery is not the issue, you will need to check the charging system and voltage regulator to see if they are functioning properly. If the problem persists, it is recommended that you have the motorcycle inspected by a qualified mechanic. They will be able to diagnose the problem and recommend the appropriate repairs.

It sounds like the battery is flat. Turn the headlight on and try and start it. Does the headlight turn into a dim glow worm?

It is a known issue https://www.google.com/search?q=2005+triumph+america+no+power+to+start ..

Must be a loose connection in wires caused by movement. Inspect harness etc. Buy a clymer book for that model....for service&repair

That is usually indicative of a fuel supply issue. Check the Petcock is open and working. Strip and clean the carb fuel bowls and jet.

You are probably describing a frozen clutch caused by a long period of disuse - the clutch plates long pressed together under the pressure of strong springs have become frozen together. Sometimes only dismantling the clutch will cure the problem. Lots of people just keep the revs low and jam it into gear and hope the shock loading will do the trick. A much kinder method is to start the engine with first gear selected and go for a ride - changing gear without the clutch is quite a trick but possible. Keep the clutch lever pulled and by the time the engine is developing high torque in a high gear most clutches would become unfrozen...

W a factory scanner..private shops r bettr then dealers. Buy a clymer manual fir complete repair

IN WHAT Country , they sell this not just in UK. and they all do not have the same tank. some are 5.2Gallons. ok moved you out of computers,. to Motorcycles and deleted you email , do not post your email in public unless 1000 spams a day for 100 years is fun. or far far worse. (then then phish you and bam) not sure the question so will answer both. 1: mpg wrong, 2; WHAT IS THE RESERVE gallons missing in the book. ok MC 101 Are motorcycles new to you ,(ive owned too many to count) back to 1965 in fact, even had a real Triumph TR6 car (pure love there) OK MPG:? 865cc twin. guessing 35mpg. 45mpg on long trips. 2.5 gallons . (30x2.5=75miles) and 2.5gal would be 30mpg, and would be normal in the city or lots of fast stop and go. 4.4 gallons tank. below is the reports but is real bad, folks do MPG wrong. small tanks make MPG super hard to calc. unlike 20 in a car. the cure is learning to average 3 tanks. total fuel gal, and total miles, then divide. http://www.fuelly.com/motorcycle/triumph/speedmaster OR RESERVE; where is it? does your tank have fuel lever? bottom left is traditional or is your question really where is the reserve point that is missing in all online spec.. and in the book. over filling the small tanks by overriding the auto station nozzle shut off , makes MPG seem low. The low fuel lamp will illuminate approximately 3.5 litres of fuel remaining in the tank. (near 1 gallon almost) I am now reading your manual. and it's in Europe somewhere, and no clues as to reserve point. did you read your manual to see how any reserve works the book has no such word in the manual. EFI injection no EFI fuel pump likes running dry, so I bet dollars to donuts they don't make that easy. This the early warning light. (just like modern cars) never run one dry. the pump is fuel cooled and fuel lubricated, is why. that is all on fuel . tell what is the problem, your post is only a hint. ok? good luck, and ride safe.

Sounds like an ignition module is going open after warming up. Check for spark after it is warm and doesn't run.

Library sec629 has cycle books