20 Most Recent
2004 TM Racing MX 125 Questions & Answers
MY TM 125
Hi,
The TM 125 uses 550 ml of gear oil. There is level inspection screw situated behind the rear brake lever. Access is a little tricky, but not too tough.
For racing motocross I recomend ATF, but must be changed after each race day.
For enduro, outriding or Sunday riders, BelRay -Trans Oil 80 W is best. You should change oil roughly every 500 km to prolong gearbox life.
Regards
Jon
Clutch fluid
Use 5wt. fork oil or ATF Dextron II/III. I've use both and have the 5wt. fork oil in now. Suppose to have a lighter pull but can't really tell any difference. Use a large syringe to pump the oil in from the bleeder at the bottom up to the master cylinder.
Clutch wont engage
Are you sure that you have all the air out of the line????At the lowest point in the line, break the line and pump fluid all the way thru, without empty the resv.!!! Do this about 3-times and you should have all the air out.
Are you sure the the clutch is pumping up and not bleeding bad thru????
Clutch
Press the clutch lever in, if it's soft it's still air bound and needs to be bleed. Press the clutch in and it's hard but smooth, see if it's moving your cluth lever on the engine, if not again try bleeding line till all air out. Press the clutch and everything external to engine is moving , you have internal clutch problems.
Hi ive got a tm
you dont need racing piston,,get the first gear fixed,some v-force3 reeds and a good pipe and you will blow the kx into the weeds
Hello, i need assistance with
It will need a battery, they wont work wired straight to the alternator, if it doesnt have a battery it will also need a regulator\rectifier
Hi i cant tell year
Contact the dealer or manufacturer and tell them the frame number. They should be able to tell you exactly what you have.
How do i alter the
if your bike has a carbertor theres a screw that you can tern to adgust how much fuel goes into the carb this will make the engine run rich or lean
Moterbike kill switch were do i wire it to
Hi
Wire it so that the neutral wire from the ignition coil gets switched to earth when kill switch turned to off position
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
2003 TM 250 4 stroke motorbike help oil dripping
You will need to replace a gasket , from where the oil is leaking from , as you dont say from what side of the bike , you must take off any covers such as chain cover that hides the drive sprocket from the motor if that is were the oil is coming from so you can identify the exact location or wash the bike down so as to wash of most oil and then run the bike to see were the oil will start leaking from
12/8/2017 11:32:40 PM •
TM Racing...
•
Answered
on Dec 08, 2017
Not finding what you are looking for?