20 Most Recent 2006 Suzuki SV 650 Questions & Answers


Make sure your clutch lever, neutral position, kickstand and kill switches are all working.
You could also try removing the negative lead for the battery for about 1 minute and reattaching, and trying again to see if that clears it.

2006 Suzuki SV... | Answered on Mar 06, 2018


It sounds like you have a flat battery. It would be a good idea to test the charging system once you have the bike running.

2006 Suzuki SV... | Answered on Aug 28, 2011


Clicking is a sing of a week battery or battery connection..

Charge it and check the connections and it should be better..

Have a gerat day !

2006 Suzuki SV... | Answered on Dec 29, 2010


Check to make sure the battery is fully charged and that the fuses are all good. If you push the starter button and the solenoid clicks, the button is good. Take a wire and jump the two posts on the solenoid or touch the two cables together, if your starter works, then you need a new solenoid. If you hold the starter button and tap on the starter with a plastic hammer and the starter works you need new starter brushes. Anything else wrong with the starter and you need to replace the starter assembly , unless the manufacturer sells replacement parts so you can repair the starter. most manufacturers only sell replacement starter brushes but no other internal starter parts.

2006 Suzuki SV... | Answered on Dec 28, 2010


Suzuki recommends the use of SUZUKI PERFORMANCE 4 MOTOR OIL or an oil which is rated SF or SG under the API (American Petroleum Institute) classification system. The viscosity rating should be SAE 10W-40. If an SAE 10W-40 oil is not available, select an alternative according to the information below: -4°F - 86°F: 10W-30 -4°F - 104°F+: 10W-40, 10W-50 6°F - 104°F+: 15W-40, 15W-50 14°F - 104°F+: 20W-50 Engine life depends on oil amount and quality. Daily oil level checks and periodic changes are two of the most important maintenance itmes to be performed.

2006 Suzuki SV... | Answered on May 26, 2010


The speedo drive sender is very common failure on these bikes following any maintenance involving the front wheel removal (like tire replacement) 
The speed sensor is located on front axle on the right side of the wheel 
The magnetic rotor gets broken because the drive detent is not properly engaged duing re-assembly. 
Fortunately the replacement is relatively inexpensive and reasonably easy to replace if you are careful to engage the drive properly when re-installing wheel. Insert the drive into the wheel before bringing wheel up to forks and inserting axle. 

2006 Suzuki SV... | Answered on Aug 15, 2009


it sits right on the front sprocket cover

2006 Suzuki SV... | Answered on Aug 15, 2009


Make sure your choke is fully in closed possition> Sitting up for that long could have allowed vanish to not allow it to seat and cause an overly rich condition

2006 Suzuki SV... | Answered on Jul 25, 2009


BAD BATTERY CABLES NOT GROUNDED BAD CONNECTION

Suzuki SV 650... | Answered on Jul 02, 2013


You need 3 things for an engine to run; spark, fuel and compression. How is the compression? Is the spark plug new? If the plug is old, it could give a nice spark when you check it but have no spark under compression. Make sure the fuel you're using is fresh. If you give it a small shot of starting fluid and it fires up, your fuel delivery is suspect. In that case, you will need to remove the carb an THOROUGHLY clean it paying close attention to jets and passages. I always give people this warning: when cleaning jets and passages, NEVER use steel instruments. Use wood, copper wire or other materials that are softer than the material you're working on or you run the risk of ruining jets or even the entire carburetor.

Suzuki SV 650... | Answered on Jun 27, 2011


check the clutch cable if its working... dismantle the body engine cover where the edge is connected,check if it is working...

Suzuki SV 650... | Answered on Jun 02, 2011


Improper timings makes backfire check the timings.

Suzuki SV 650... | Answered on Apr 07, 2011


Hi, use your key to open the side panel. You have to unscrew both battery posts in place, then slide the battery out. Don't loose the nuts that the battery screws screw into. Once the battery is charged, you need to put the nuts in place inside the terminals and carefully slide the battery in without disturbing the nuts. Then the screws will go into the nuts for tightening. Always loosen the negative cable first and replace it last to minimize the chance of shorting the positive to ground when attaching the positive cable. Please let me know if you have more questions. I have one of these and I have the manual for it.

Suzuki SV 650... | Answered on Mar 15, 2011


Hi and welcome to FixYa!

Yes it may but as a first course of action I strongly suggest that you replace the fuel filter. It can be clogged causing fuel supply irregularities. If it still doesn't help then replace the fuel pump and you'll be good.

Hope this helps and thank you for using FixYa! Have a good one!

Suzuki SV 650... | Answered on Jan 07, 2011


r u gitten gas from the tank fawcett? is pump hooked up rite and producing pressure--carb or injectors may need ajustin--buy a clymer manual

Suzuki SV 650... | Answered on Oct 08, 2010


First the i would do is clean the carb.

Suzuki SV 650... | Answered on Jul 20, 2010

Not finding what you are looking for?
2006 Suzuki SV 650 Logo

16 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

SV 650 Suzuki

  • SV 650 Suzuki

Most Popular Question

problem suzuki sv 650

  • Motorcycles
Loading...