20 Most Recent 2007 Harley Davidson XL 883 Sportster Questions & Answers


Hi, Rana for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Harley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected] Good luck and have a wonderful day.
How to Disable Harley Davidson Factory Security and Use Transport Mode
2007 Harley Sportster Service Manual pdf
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/007-harley-davidson-owners-manuals

2007 Harley... | Answered on Aug 24, 2018


Hi, Robert could be your ignition switch is faulty or you have a sticky starter solenoid/relay, for this scenario you will need your service manual, parts fiche, and owners manual if you can not find the best tool you ever bought for your Harley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected] Good luck and have a wonderful day.
Electrical issues starter switch or relay Harley Davidson Forums
Harley Davidson 2005 Sportster Service Manual
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/007-harley-davidson-owners-manuals
Instant Tech Relief To speak to me personally $6 very cheap

2007 Harley... | Answered on Jan 31, 2018


Hi, Sylvain before testing any electrical component in the Starting System it is "IMPERATIVE" that you have a fully charged battery of 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage, the battery is faulty and must be replaced. AGM type batteries fall into this scenario more so than lead acid batteries.
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter.
4. Bank angle sensor needs a reset or is faulty.
5. FOB battery low or dead.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand, clutch, neutral safety switch.
9. Security alarm needs a reset.
10. Starter relay, solenoid, starter motor or circuit wiring faulty.
11. Starter armature or field coils have failed.
12. Main fuse or circuit breaker may be blown or faulty.
13. Faulty ignition relay.
14. The electric starter is working but starter clutch has failed.
15. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected] Good luck and have a wonderful day.
07 883 Sportster Won Start
Harley Davidson Sportster Workshop Service Repair Manual 2007 $8 very cheap includes a $60 electrical diagnostic manual
http://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/007-harley-davidson-owners-manuals
Instant Tech Relief To speak to me personally absolutely "FREE"

2007 Harley... | Answered on Jul 30, 2017


Hi, David I have gathered a few companies that offer low prices for more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Cable Kits Cycles
Search
Search Harley Davidson Manuals Mark Workshop
Search Drag Specialties

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on Sep 10, 2016


Hi, David the 5/8" round bar stock would be stronger for more information about your question and valuable "FREE" downloads that you will need please click on the links below and for specific answers or questions at no charge please feel free to contact me at [email protected] Good luck and have a nice day.
Harley Davidson Manuals Mark Workshop
http://www.stcharlesharleydavidson.com/OEMpartfinder.htm
https://serviceinfo.harley-davidson.com/sip/index
Instant Tech Relief A must have !!! only $6 a month "CHEAP"

2007 Harley... | Answered on Sep 05, 2016


You can get a replacement clutch for about $146 that is a complete replacement of your clutch plates. It has the extra plates to replace that poor designed spring plate that comes standard on your Sporty
-or- you can buy, for about $190 that same clutch plate kit AND includes the clutch spring tool with it. Here is a link, if you are interested in seeing. Still should have the manual to take the case and clutch apart and put back together though. The kit works great! I have replaced several of them for my friends and never had a problem. Here is the link to where you can get them, but feel free to do some shopping around if you like. The link is just where I have found them at a reasonable price and the spring tool is one of the easiest to access the spring retaining ring too. Anyway, here is the link I use to order mine and my friends replacement kits.

Sportster and Buell Performance Extra Plate Kit

OBHighflyer (aka Scott)

2007 Harley... | Answered on Jul 25, 2016


Hi Edgar, you may need an alarm reset, for more information about your question please visit the website below. Good luck and have nice day.
Set Change Override Transport Harley Security Alarm PIN Code No Key Fob...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2007 Harley... | Answered on Jun 17, 2015


Hi Anonymous, seat removal can range from the simple and obvious to the complex and baffling for the novice new Harley Davidson owner. Seems like the more expensive the bike is the harder it is to remove the seat. So let's start with the most expensive. 99% of all Harley seats have a male tounge in the front that slides into a female reciever that is either bolted or welded to the frame just behind the fuel tank. For this reason when ever you are removing a seat you must always slide it backwards 3-5 inches. Next they may may have a bolt on each side usually under a flap on the seat. Then there is the seat strap that is secured on both sides, only one side needs to be removed. A single phillips head bolt can secure it to the rear fender or it may have a bracket with two studs secured by nuts or knobs to fasten the rear portion of the seat. On newer model short seats there may be a "T" stud that locks in the rear portion of the seat just a few inches in front of the rear seat bolt, you have to push forward and lift up after you remove the bolt. If you have a pillion pad or passenger seat that snugs up against the front seat there can be a bolt securing the two to the rear fender, you have to get your hand in between the two seats and force seperation of seat material to see and gain acess to the bolt. Finally there is the rear seat bolt in the back that is the caboose of seat fasteners, usually a large chrome bracket, that screws into the rear fender. Care must be exercised in covering this shinny bauble with your hand during the sliding back procedure so as to NOT scratch the tour pak. So when all the hidden and mysterious fasteners have been removed, it's lift up in the rear, slide backwards a few inches and bingo you have mastered the impossible. Good luck.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on Jun 17, 2015


Hi Anonymous, if you have a carbuerator the petcock/fuel valve is located on bottom rear of the left side of the fuel tank. With the long end of the lever pointing straight back the fuel valve is in the off position and no fuel will flow to the carbuerator, with it pointing straight down the valve allows fuel flow from the gas tank to the carbuerator, with it pointing straight forward it is in reserve mode and you have roughly 1/2 to 1 gallon of fuel left in the gas tank. If you are fuel injected the is a low fuel warning light either on the dash or speedometer. If you have a fuel gauge refuel before it hits empty just like your car. Good luck and have nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on Jun 17, 2015


Hi Drkltsjc, for more information about your question please visit the website below. Good luck and have nice day. Harley Check Valve Rebuild Kit

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2007 Harley... | Answered on Jun 15, 2015


Hi Anonymous, I'm sorry but I just loaned my listening ears to the lead technician at your local Harley Dealer so he could take your bike for a test ride and evaluate the noise. Have a nice day.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on Jun 15, 2015


Hi Mary, for more information on your question please visit the websites below and good luck:
Investigating Sportster clutch noise

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2007 Harley... | Answered on May 21, 2015


Hi Steven, for more information on your question please visit the websites below and good luck:
http://xlforum.net/vbportal/forums/archive/index.php/t-39135.html
Bike will not start Harley Davidson Forums HDTalking com

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Anonymous, for more information on your question please visit the websites below and good luck:
http://xlforum.net/vbportal/forums/archive/index.php/t-65281.html
Harley Sportster fuel pump and filter

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2007 Harley... | Answered on May 19, 2015


Hi Anonymous, always check the bulbs first for broken filaments. Then check the connection at the rear fender wiring harness, inspect for corroded, broken or loose pins. Use a dab of dielectric grease and repair as necessary. Check your brake relay if you have one. For a free wiring diagram please visit the website below and good luck: Harley Davidson Wiring Diagrams and Schematics

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Mroger1, for more information on your question please visit the websites below and good luck:
Harley Davidson Sportster error codes and how to access them

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Jsore, your information about OEM Primary Chaincase Lubricant is faulty for more information on your question please visit the websites below and good luck:
Harley Davidson Sportster error codes and how to access them

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Jivecebu, hard to say check with your local dealer. Good luck

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Mglee316, for more information on your question please visit the websites below and good luck:
TSM TSSM HFSM How to disable alarm and or replace unit
2007 XL883L tipped wont start Harley Davidson Forums
Can disarm my alarm Harley Davidson Forums HDTalking com

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2007 Harley... | Answered on May 19, 2015


Hi Skeeterwolf7, for more information on your question please visit the websites below and good luck:
Delboy Garage Harley Sportster Battery Replacement

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


2007 Harley... | Answered on May 19, 2015

Not finding what you are looking for?
2007 Harley Davidson XL 883 Sportster Logo

133 questions posted

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6216 Answers

Mike

Level 3 Expert

4369 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

XL 883 Sportster Harley Davidson

  • XL 883 Sportster Harley Davidson

Most Popular Question

looking get custom sissy bar 07

  • Motorcycles
Loading...