20 Most Recent 2007 BMW R 1200 GS Adventure Questions & Answers

remove the cover ,wind motor over to Top Dead Centre ,look for timing marks (may need to turn over once more to get all the marks to line up) Mark all the reference marks with a white paint pen to make them clear , Release the tenenser & lock it out remove the old belt ,refit the belt making sure the marks all line up release the tenenser and lock it ,recheck your marks ,wind over by hand a couple of times to check everything is OK refit covers

be careful these bikes have CAN_BUS wiring systems, you start messing with the wiring and it starts effecting all the other function

Take it to a BMW service dealer or an independant who can service it as they need a special machine to set up correctly

If you have the film type sensor, it cannot be repaired and will need to be replaced. You will need to remove the filler cap (6 screws). Then remove the metal "funnel" part. The fuel strip is attached to the funnel part.

Your ABS pump is faulty. Contact these guys: motorcycle repair They repair the ABS units with a 5 year warranty.

If yours is a 2007 model, chances are good that the ABS pump has failed and needs to be replaced. Alternatively, look here: motorcycle repair They repair the ABS units with a 5 year warranty.

No, Diagnostic software cannot measure your clutch wear. Remove the starter motor. You will be able to see a small section of the clutch and measure the thickness.

There is no fuse box. All electronic fuses which are controlled by the CanBus.