Top 20
2003 Hyosung GV 125 Aquila - Page 4 Questions & Answers
Rotate throttle and bike dies
Is your bike a fuel injected? if yes most chances are a faulty fuel pressure valve.Just enough fuel to idle but when you open throttle it will choke(starve)and die.Carburated? Main jet clogged or a Mal adjusted float height
11/17/2013 12:34:57 AM •
Hyosung...
•
223 views • 0 helpful votes
Hyosung sense kick problems
Hyosung used a very bad quality side stand switch on some models. I just removed the switch located at the stand's pivot and short the leads to bypass the switch. Note that you are not protected by this safety feature any more and must be very careful not to ride with the stand down. It is not a big deal and you get used to checking that as you become a better rider.
11/18/2013 3:21:36 AM •
Hyosung...
•
195 views • 0 helpful votes
Replace rear wheel
it is just a vent line. it goes to the bottom of the air box.
12/3/2013 10:53:52 PM •
Hyosung...
•
36 views • 0 helpful votes
Gear indicator help
im not sure on the gear indicator, but your main bearing might be too tight or need lubricating. sorry its not much help
9/12/2013 5:30:27 PM •
Hyosung...
•
200 views • 0 helpful votes
Starts runs wont accelerate
It seems there is fuel starvation when you reach that speed or the spark plug seems to fail.(1) Check the spark plug and also see if it's of a correct specs per the manufacturer's recommendation.(2) There could be a blockage in the carb's main jet which restricts the flow of fuel at that speed.Hope this helps!
5/4/2013 5:40:41 AM •
Hyosung...
•
874 views • 0 helpful votes
250 fuel pump
It is possible to rebuild anything that a human has put together. The real question is, Is it worth it? You can get a service kit and rebuild it that way. But, it would depend on the reason for the failure of the pump.
6/6/2013 8:38:47 PM •
Hyosung...
•
202 views • 0 helpful votes
Rear disk brakes on motorcycle are not working
Assumeing you have been trying to bleed the brakes and assumeing you tried that because your brakes quit working. Check a couple things. First try opening the bleeder first then pushing the peddle and see if fluid moves. Next make sure the piston in the master cylinder has its full range of motion ( not a lot of slop in the pedal at rest ). If you have these symptoms then you likely need a master cylinder rebuild. If you keep losing fluid you have a leak, and if you just changed a a bunch of stuff then its start at the beginning by bleeding the master cylinder.
10/25/2012 12:47:38 AM •
Hyosung...
•
231 views • 0 helpful votes
Charging the battery
If you have a battery charger, remove the battery cover to expose the battery terminals then you can connect the battery charge to the battery.Make sure you connect the positive lead from the charger to the positive terminal on the battery and the negative lead from the charger to the negative terminal on the battery before you power up the battery charger.When you have finished charging the battery, power off the battery charger before you disconnect the leads from the battery.
7/3/2012 10:05:29 PM •
Hyosung...
•
428 views • 1 helpful votes
Not finding what you are looking for?