20 Most Recent 2003 Hyosung GV 125 Aquila - Page 5 Questions & Answers


You need to connect the two wires coming from the loom to the sensor. If you actually 'cut' the cable it should be easy. Make sure you connect the wires coming from the loom, not the sensor.

Hyosung... | Answered on May 12, 2015


It does sound like a kickstand sensor issue, as the sensor only works when the bike is in gear. To check, you can bypass the sensor by disconnecting it's cable and then joining the two wires together so there's a permanent electrical connection. If that solves the problem, you need a new kickstand sensor.

Hyosung... | Answered on May 12, 2015


there will be a special puller for the job
contact the shop and see if you can buy one.

Hyosung... | Answered on Apr 07, 2015


I suspect that the alternator / regulator has failed as the battery is not big enough to run the light alone
have it check out at an accredited bike shop electrician

Hyosung... | Answered on Mar 23, 2015


I doubt it has caused any real damage or it would be making a funny noise or smoking but why did they rev it that high, you should have asked them what they were doing.

Hyosung... | Answered on Mar 10, 2015


lack of fuel or or has an air leek somewhere,check spark plugs.

Hyosung... | Answered on Nov 19, 2014


Follow the red wire from the battery. A smaller red wire will branch off the large one and include a fuse holder, or it may be included as a part of the starter solenoid.

Hyosung... | Answered on Jun 22, 2014


1. is the battery connected?
2. negative to negative positive to positive.
3. fusible link?
those are a start

Hyosung... | Answered on Feb 10, 2014


it is just a vent line. it goes to the bottom of the air box.

Hyosung... | Answered on Feb 10, 2014


at idle it could be in the low 12s or even 11.** but at any rpm above 1500 it should be at least 13.6 and not over 14.6.
If not you have a charging issue.

Hyosung... | Answered on Feb 10, 2014


what procedure of replace piston/rings

Hyosung... | Answered on Feb 07, 2014


Try looking at the ignition fuses, could also be a bad earth to the starter motor. When you turn the key do the lights dim at all,

Hyosung... | Answered on Jan 25, 2014


Lowest part of the bike, should be

Hyosung... | Answered on Jan 11, 2014


You should have 13.2 volts to around 13.8 volts at tickover and at 2000 revs much more and you are overcharging which is bad, and generally anything below 13.2 even with all accessories turned on will signify a problem brewing most likely with the reg-rec.

Hyosung... | Answered on Jan 11, 2014


check air filter, spark plug and fuel delivery in that order. then check for plugged exhaust, valve adjustments and then timing. in the mean time answer these questions. is the gas fresh and from a known good source ??? did you do anything to it recently ??? is the engine revving high while you are moving ???

Hyosung... | Answered on Dec 04, 2013

Not finding what you are looking for?
2003 Hyosung GV 125 Aquila Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Hyosung Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6394 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Are you a Hyosung Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

GV 125 Aquila Hyosung

  • GV 125 Aquila Hyosung

Most Popular Question

hyosung gv 125 aquila top speed

  • Motorcycles
Loading...