1984 Honda VT 500 C - Answered Questions & Fixed issues


Check your oil. If it is too full , change it. Occasionally the Honda's of that time would have the float stick and fill the engine with gas. There may actually be nothing wrong with your cycle , new bikes did this. If gas filled the cylinder and went into the exhaust you probably have a stuck float. If the problem happens again you may have to disassemble and clean the carburetors , replacing the float needles at that time. One good way to keep your oil from filling with gas is to always turn off your gas at the fuel petcock after riding. Be sure to check your air filter for gas/oil saturation and be sure to pull the plugs on your pollution tubes under the air box to drain the blow by.

1984 Honda VT... | Answered on Oct 23, 2010 | 218 views


Sorry there is none that will interchange.

1984 Honda VT... | Answered on Oct 28, 2009 | 123 views


Hey pal !...Google motorcycle salvage yards and your results will lead you to a vast deposit of used motorcycle parts,maybe one close by, but they do ship....Good luck to you friend...Tim

1984 Honda VT... | Answered on May 14, 2009 | 99 views


Clean and rebuild the carbs as a first step. Is it a ping, knock, or rattle?

Honda VT 500 C... | Answered on Sep 10, 2012 | 292 views


You ill need to take off your left engine cover, remove the flywheel, and replace the starter gear (part#5) and three rollers (part#13). This is your one-way clutch that allows your starter motor to turn the engine over. The gear mating surface has become rough or chattered and is not grabbing properly.Replace these parts and your starter motor will turn the engine over again. http://www.bikebandit.com/houseofmotorcycles/1983-honda-vt500c-shadow/o/m9690#sch421900

Honda VT 500 C... | Answered on Sep 18, 2011 | 268 views


The fan is designed by Honda to come on just as the needle touches the red zone, or just slightly before it.But if its not coming on then its problem with fan.It should come On.You can provide 12 volt to fan connections directly by external battery source and see, if fan starts and runs directly.If the fan runs by external 12 volt source then its problem with fan controlling relay under seat.But if fan is not running by external 12 volt direct source then its problem with fan and needs to be replaced.---------- But if fan checked out ok and fan relay looks fine and checked ok, 12 volt by meter, then its problem with thermostat.------ The thermo-switch that operates the fan is on the bottom of the radiator and the thermo unit for the gauge is on the side of the thermostat. The fan does not turn on until the coolant in the bottom of the radiator is up to a certain temperature. The coolant can be hot at the thermostat and much cooler at the bottom of the radiator.

You may want to drain the coolant and look inside the top of the radiator for corrosion or anything restricting the coolant flow. If it looks dirty, take the radiator off and take it to a radiator shop to have the inside cleaned.------------- Once the rad is completely flushed cleaned the coolant has to be refilled.------- This will help.Thanks.Helpmech.

Honda VT 500 C... | Answered on Aug 20, 2011 | 100 views


Check the main fuse on the starter solenoid. If it blows everything just shuts down. Follow the positive battery cable from the battery to the starter solenoid and replace the fuse. If that does not fix the problem remove the battery and have it load tested. A simple way to test for a broken cell in a battery (if you do not have a load tester) just jump the two starter solenoid terminals with a piece of wire or a screw driver, if there is not enough power to move the starter you may have a broken connection between the cells in the battery. Then you just need a new battery. My bet is you just need to replace the main fuse.

Honda VT 500 C... | Answered on Apr 20, 2011 | 106 views


I would add the following thoughts for consideration. Many things can cause this, some are, from a short driving cycle that doesn't allow the engine to fully warm up, to a faulty fuel pressure regulator, to leaking fuel injector/s or a carburator float bowl being overfilled, to worn engine parts, like piston rings, valve guides, faulty spark plugs resulting in poor fuel burn ect, ect. Basically it's gasoline getting from the top of the engine, into the bottom of the engine, where the oil sump is. Gasoline in the oil isn't good for it, or the engine, as it dilutes the oil & robs it of it's lubricating properties, resulting in accelerated engine wear & bad engine deposits. Best to change the oil & filter right away, review all the listed ideas & have the most likely checked out by a pro you trust. If your bikes mechanical condition is ok, but your driving cycle is short, after changing the oil & filter, try changing your driving cycle, or by taking your bike on a weekly 20 mile interstate round trip, to warm the engine & oil up competely, to evaporate condensation & any gasoline thats found it's way into the crankcase oil sump. Your ride will love you for it & the gas oder in the oil, will likely take a hike!!!! your bike is not good mechanically or u would not be getting fuel in oil. take it to a REPUTABLE mechanic and get it looked at .problem may be small and easy to fix. the longer you wait the worse it will get

Honda VT 500 C... | Answered on Jan 17, 2010 | 246 views


the choke is not turning off, or off soon enough. inspect and clean/adjust choke assembly, your carbs may be gummy

Honda VT 500 C... | Answered on Aug 09, 2009 | 240 views


I have a 94 magna that had the very same problem. I thought it was a problem with a stopped up carb or gas line but determined the battery connections had worked loose. Tighten the battery connections. Since you are there also check the fluid level in the battery. Only use distilled water to refill the cells NEVER tap water. You can buy distilled water at most grocery stores or WalMart for about a buck a gallon. Hope this helps.

Honda VT 500 C... | Answered on Jul 08, 2009 | 128 views


If it will not spin over at all I'd check the battery and starter connections and battery state of charge first .

Honda... | Answered Yesterday | 12 views


maybe nos or junkyard. its gonna be a long search for you. check e bay also...good luck

Honda... | Answered on Nov 17, 2020 | 16 views


To run a petrol internal combustion engine it requires four things.
Air
Fuel
Compression
Ignition.
Which is missing ...............................

Honda... | Answered on Nov 13, 2020 | 13 views


Valve clearance need adjusting a fraction. not dangerous, better to be a tad loose than too tight and have valves partially open.

Google

year make model adjust valve clearance

It's an easy job and will take 15 minutes with basic tools and a feeler gauge.

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk03IHsZ6iXxD-60eHjyK0Amn6xmIrA%3A1604713857741&ei=gf2lX-LfLNXQtQaV77ww&q=honda+160cc+valve+adjustment

..

Honda... | Answered on Nov 07, 2020 | 52 views


<a href="https://portabledownloads.com/maxon-cinema-4d-studio-r22-with-crack/ "> Maxon Cinema 4D </a> Maxon CINEMA 4D Studio R22 With Crack Introduces powerful new tools, opportunities, and improvements in modeling, animation, and shading. The perfect package for all 3D artists, both beginners and professionals. It has a wide range of tools and resources to quickly achieve impressive
<a href="https://windowcrack.com/pixologic-zbrush-2020-1-3-crack// "> Pixologic Zbrush </a>

Honda... | Answered on Nov 03, 2020 | 107 views


Hi, Rene for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://itstillruns.com/remove-honda-shadow-starter-5007585.html
https://www.hondashadow.net/threads/starter-removal-on-vt1100-shadow.434250/
https://www.manualslib.com/manual/1188474/Honda-Shadow-Vt1100.html
https://www.partsfish.com/page/oem-parts-for-honda
https://www.manualslib.com/manual/899170/Honda-Shadow-Vt1100.html

Honda... | Answered on Nov 02, 2020 | 41 views


Hi, Benny for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?sxsrf=ALeKk00Ke070HT_38mpoB7-cEtaQ5ULDew:1604340664889&source=univ&tbm=isch&q=Shifter+will+not+return+to+its+proper+place+honda+tmx+125&sa=X&ved=2ahUKEwiaobfbuuTsAhXqt1kKHW31BboQjJkEegQIAhAB&biw=1440&bih=757
https://www.youtube.com/watch?v=PJtElClDQrM
http://onthelastepisode.com/forums/topic/honda-tmx-125-alpha-service-manual/
https://www.partsfish.com/page/oem-parts-for-honda
https://www.manualslib.com/manual/1638127/Honda-Wave-110-Alpha-2018.html#product-TMX%20125a%202018

Honda... | Answered on Nov 02, 2020 | 54 views


Hi, Mike for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?sxsrf=ALeKk01Okl2d16DczFcHcoO5tIe34ytNsA:1604247315638&source=univ&tbm=isch&q=How+to+remove+the+flywheel+Honda+TMX+155&sa=X&ved=2ahUKEwjPhYX73uHsAhWlp1kKHZHXBSgQjJkEegQIERAB&biw=1440&bih=757
https://www.youtube.com/watch?v=B7Ne2yPgIqk
http://www.magnariders.cz/files/hcsm.pdf
https://www.partsfish.com/page/oem-parts-for-honda
https://www.manualslib.com/manual/1681597/Honda-Tmx-Supremo-Series.html

Honda... | Answered on Nov 01, 2020 | 49 views

Not finding what you are looking for?
1984 Honda VT 500 C Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...