20 Most Recent 1976 Honda CB 100 Questions & Answers


possible carb/intake issue - 1.remove /clean air cleaner -test 2. clean carb - test 3. remove carh assembly thoroughly clean disassemble replace bad parts with rebuild kit, clean all areas reassemble - test

1976 Honda CB... | Answered on Jan 06, 2014


Check the petcock to make sure it's actually working. If there is a little nipple on the back of the petcock then make sure there is a line coming off of it. If there is then **** on it while the gas is on but the fuel line disconnected. If you apply 3-5 psi of pressure then the diaphragm will release and gas will flow. If not then you need a new petcock.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

1976 Honda CB... | Answered on Dec 16, 2013


check the carb float level ,and condition of needle and seat

1976 Honda CB... | Answered on Aug 10, 2013


you may have the belt to tight . th model you have was reversed engineer from a old honda 50 that was made back in the 60,s this should be a automatic. and may have a bad neutral switch

1976 Honda CB... | Answered on Jun 01, 2011


This sounds like no fuel flow to your carb. I would proceed as follows:
Pull fuel hose from the inlet of the carb and see if you have flow, if not, check for plugged screens. While in this step, consider draining all fuel and replace with new fuel.

If you did have fuel flow, you will need to take the carb(s) apart and see what is wrong. Some times the float needle gets stuck and a moderate tap on the carb body with a screwdriver handle sometimes releases it, otherwise, you need to open the carb and look for gummed up orifaces and inlet valve issues.

1976 Honda CB... | Answered on Apr 06, 2011


A fresh bore job should have a piston to wall clearance of .002"if its .005"then its boarder line,anything after that then bore to next size.

1976 Honda CB... | Answered on Mar 16, 2011


Take your carburetor apart and clean it. Paying close attention to the slow jet and slow jet passageway through the carb.

1976 Honda CB... | Answered on Sep 05, 2010


in adition to the above coment, which i must say is spot on, the posability of a used barel and piston if a new piston is not available could be worth considering, other things you may wish to check on that particular engine is camshaft seizure, in a uk bike it runs directly in the machined surface of the cylinder head, oil failure due to blocked oil filter has severe consequenses, located on the l/h side of the engine under a 22 or 24mm spaner head cap just below the gear change lever, this is a washable filter retained by a cap and spring, correct replacment is inperitive. are you located in UK? HOPE THIS HELPS YOU

1976 Honda CB... | Answered on Aug 03, 2010


it sounds like your float is stuck . you can lightly tap it to unstick it but it might happen again the best course is to take it apart and clean or replace it

1976 Honda CB... | Answered on May 09, 2010


NKTEL 2008 DISPLY PROBLUM

1976 Honda CB... | Answered on May 07, 2010


Be patient try EBAY or salvage yards(many of whom can be contacted on line.

1976 Honda CB... | Answered on Apr 30, 2010


Your bike will only run at full throttle if your cable or main jet needle are stuck in the full throttle position .Take your throttle cable off and check that its freely working inside the outer caseing .

1976 Honda CB... | Answered on Mar 22, 2010


Your listing is confusing ... is it a CB-100 or is it a xport 110?

In either event, I think your cable is broken. If the cable is NOT broken, it is time for a new clutch on this 33 year old veteran. You will find detailed generic instructions at the Honda Riders Club House (search Honda Rider Club). If you pay the couple bucks to join, according to information at the site, Honda will give you access to the service manual for your motorcycle.

My first bike was a CB 100 - it is one of many great bikes built by Honda.

Thanks for your question at FixYa.com

1976 Honda CB... | Answered on Jan 02, 2010

Not finding what you are looking for?
1976 Honda CB 100 Logo

Popular Tags

43 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6576 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

CB 100 Honda

  • CB 100 Honda

Most Popular Question

having problems starting honda ruckus

  • Motorcycles
Loading...