20 Most Recent
2008 Derbi Senda Baja 125 R Questions & Answers
Broken back wheel bearing
yes it is normall buddy if not regualry greased and oil and cleaned pop it out with a screw driver but if its hard to get out heat the outside up and pop out
Drain and change oil
I can't tell you all the particulars from the limited amount of pictures of your bike. -Remove the oil drain bolt on the bottom of the crankcase (the universal bolt size for bikes use a 17mm wrench). -Drain the oil (remember to recycle). -Re-install the drain bolt with a new sealing washer if necessary. -The oil fill cap should be some where on the top of the crankcase. About 1 or 25mm in diameter with a raised tab for turning. -Fill with recommended oil. -There are 2 ways to check oil level on dirt bikes: 1) Oil level check bolt. On the right side cover. 2) Oil level site glass. A 1 round piece of glass on the side of the crankcase. Usually by the kick start & R brake lever. -Always check the oil level with the bike upright (as if you were sitting on it). -Check bolt - fill with oil slowly until oil comes out of the check bolt and re-install it. -Sight glass - fill with oil to cover 3/4 of the sight glass. -Remember to hold the bike upright when adding oil.,
My Derbi City Cross will not start
I know you said you cleaned the carb, but maybe something got in the carb when trying to start the bike. Because it sure sounds like you have a clogged pilot jet.
10/21/2022 3:56:02 PM •
Derbi...
•
Answered
on Oct 21, 2022
How do I get rid of an airlock in the coolant system of a Derbi GPR 125 2009
Use a airlift or comparable coolant system air removal/refill system.You attach the unit to the coolant system filler and it vacuums all air from the system,then you use the supplied hose to return the coolant into the vacuumed system.This fills the system with just coolant and no air.
2/19/2019 10:58:33 PM •
Derbi...
•
Answered
on Feb 19, 2019
Not finding what you are looking for?