20 Most Recent
2011 TVS Scooty Pep Plus Questions & Answers
Front Lighting and Horn are not working in TVS Scooty Pep
Dear Friend,
Its seems that, there is fault or loosen in electrical wiring circuit, or please try to check your switches, whether the wire connections are connected properly, due to rain or water moved inside to switch areas, problem occurs usually, better try to visit your nearest 2-wheeler workshop, they will rectify your problem.
Scooty Pep+, bike vibrating,
Dear Friend,
Please try to visit your nearest 2-wheeler workshop, it seems that there is some problem with your engine or some of your body parts have been loosen or due to some friction. before judging all these we need to inspect, where the friction is coming from.
How to open tvs scooty pep+ seat without key 2007
Dear Friend,
Please try to visit nearest workshop to do this procedure, if you are trying to do by your own, you may loss your lock of your seat, better go to them, after sometime you can able to use the same lock, by getting one duplicate key, other wise you want to complete set of new lock and key, which may cost around Rs.600/-.
Wiring diagram
i have a scooty pep plus its not take kickstart without battraywhat to do?
Sir, my Scooty pep plus
MAY BE YOUR FUEL IS IMPURE..
TRY CHANGING YOUR FUEL STATION (CHANGE YOUR FUEL STATION ONLY WHEN YOUR TANK IS COMPLETELY EMPTY)
THIS MIGHT HELP..
Oil replacement
Exactly below the engine near rear Tyre, to see this you have to bend the scooty fully. there is a small nut we can operate it with a spanner, that is for gear oil drain. at the center portion there is a big aluminium nut of about two inch diameter which can only be operated by key , that is for engine oil drain further detail you can contact me by
[email protected]
How to check engine oil in scooty pep plus
Locate the oil dipstick which will be made of black plastic with a raised lip for turning. The dipstick will either be under the seat on the top of the engine or on the lower side of the engine. Once located, unscrew and wipe off excessive oil. Reinsert dipstick but do not screw it in, then remove the dipstick and hold it horizontal to read the level, which should be between the two marks on the end. If the oil level is near the bottom mark, add enough oil to increase it as close to the top mark without exceeding the top mark.
Not finding what you are looking for?