2010 KTM 250 SX - Page 4 - Answered Questions & Fixed issues

0helpful
1answer

Does any one know how to fit a cd5004 ignition on

It makes sense for one part to be the pick up sensor and the other a ignition advance module
11/9/2014 1:37:30 AM • KTM Motorcycles • Answered on Nov 09, 2014 • 48 views
0helpful
1answer

Hi my name is Martin,we getting lost with my ktm

Hello, there must be a "safety unit " on your Ktm. It reads all the sensors ( tilt, neutral, clutch...) it could be faulty. If your bike doesn't have one, then the ecu does that job.... i have seen this problem on a good few Suzuki's and aprilia's when the tilt ( angle sensor) was faulty or badly relocated (when someone had fitted an alarm or changed the battery, they had it upside down). I hope this might help you Franck
9/10/2014 9:59:31 PM • KTM Motorcycles • Answered on Sep 10, 2014 • 201 views
0helpful
1answer

Transmission hard get in gear

install a new clutch. make sure chain is properly aligned and lubricated.
6/19/2014 3:26:58 PM • KTM Motorcycles • Answered on Jun 19, 2014 • 166 views
0helpful
1answer

No fuel getting injectors

check the fuel pump fuse, if getting power then replace fuel pump.
6/19/2014 3:25:44 PM • KTM Motorcycles • Answered on Jun 19, 2014 • 62 views
0helpful
1answer

Gear shift selector

wot about your gear selector ??
6/17/2014 10:51:15 AM • KTM Motorcycles • Answered on Jun 17, 2014 • 49 views
0helpful
1answer

Noise release clutch

remove the chain and check all links are free , check the rear wheel bearings are spinning free and not notchi ! check condition of sprockets teeth not worn !
6/17/2014 10:49:48 AM • KTM Motorcycles • Answered on Jun 17, 2014 • 152 views
0helpful
1answer

No electric power

Main fuse is blown, its under the seat on the + battery wire.
5/17/2014 3:52:12 AM • KTM Motorcycles • Answered on May 17, 2014 • 184 views
0helpful
1answer

Noise release clutch

Check rear wheel bearings. Be sure the chain is adjusted and lubricated properly.
5/15/2014 12:55:37 AM • KTM Motorcycles • Answered on May 15, 2014 • 145 views
0helpful
1answer

Engine clutch make nise when engaged noise goes away when clutch is dissengagued

Waren clutch and or low oil check oil with engine at running temp also check for metal shavings in your clutch oil
5/13/2014 11:56:50 PM • KTM Motorcycles • Answered on May 13, 2014 • 201 views
0helpful
1answer

Bike battery exide

Had great luck with Shorai but you will pay for it.
4/10/2014 6:01:20 AM • KTM Motorcycles • Answered on Apr 10, 2014 • 111 views
0helpful
1answer

Ktm wont idle

Clean carburetor idle jet and idle circuit.
4/4/2014 5:32:11 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 684 views
0helpful
1answer

Ktm 400 air box

94 - 96 only!
4/4/2014 5:29:25 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 137 views
0helpful
1answer

How do you bleed clutch on ktm lc4 2004

Drain the entire system and back-bleed it from the slave cylinder up with a syringe.
4/4/2014 5:25:01 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 396 views
0helpful
1answer

Petcock Valve

If the bolts are spinning you will have to drill off the bolt heads and extract the threads from the base inserts. Replace the petcock base o-ring, epoxy the base nuts into the tank body, install petcock. Or replace tank and valve. It's a choice of time or money.
4/4/2014 5:21:11 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 148 views
0helpful
1answer

65 sx boggs when on pipe

Carburetor issue. Running to rich, water in carb and tank, or filthy air filter
4/4/2014 5:09:08 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 207 views
0helpful
1answer

Exhaust flange

The ring is too keep the pipe from damaging the cylinder. The o-ring on the pipe is what seals it from leaking.
4/4/2014 4:41:18 AM • KTM Motorcycles • Answered on Apr 04, 2014 • 255 views
0helpful
1answer

Fuel sensor/reader failure

You must keep the fuel tank at least half full
3/14/2014 11:16:28 AM • KTM Motorcycles • Answered on Mar 14, 2014 • 224 views
0helpful
1answer

Ktm

buy one from your dealer.
3/14/2014 9:08:52 AM • KTM Motorcycles • Answered on Mar 14, 2014 • 44 views
0helpful
1answer

Wont start ktm 250excf

get yourself a workshop manual to do this properly
3/14/2014 8:31:42 AM • KTM Motorcycles • Answered on Mar 14, 2014 • 69 views
0helpful
1answer

Will the starter relay effect the blinkers

No the starter relay is seperate ! check all fuses and ignition system connections !
3/4/2014 11:48:31 AM • KTM Motorcycles • Answered on Mar 04, 2014 • 178 views
Not finding what you are looking for?
2010 KTM 250 SX Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2006 KTM 250 SX
2006 KTM 250 SX

10 Questions

2008 KTM 250 SX
2008 KTM 250 SX

8 Questions

2005 KTM 250 SX
2005 KTM 250 SX

3 Questions

2007 KTM 250 SX
2007 KTM 250 SX

2 Questions

2009 KTM 250 SX
2009 KTM 250 SX

0 Questions

Top KTM Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a KTM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...