2015 Suzuki RM-Z 250 - Page 5 - Answered Questions & Fixed issues


Had that problem last year and it ended up being a loose ground on the engine side... try cleaning up your contacts on the battery and on the motor... every time the sifter cable moved on my engine it would bump the ground.

Suzuki... | Answered on Mar 30, 2019 | 138 views


Check the ignition relay, because it may have overheated and gone faulty. If you can hear it click when you press the ignition button but the starter doesn't operate then the relay could be faulty.

Suzuki... | Answered on Mar 28, 2019 | 51 views


Check the feed wire that goes to the fuse block to see if it has power. There should be a main fuse somewhere close to the fuse box.

https://www.youtube.com/watch?v=fKy4Sx9dsVo

Suzuki... | Answered on Mar 05, 2019 | 25 views


As it is a vx engine going into a vs frame Suzuki may have used a different wiring harness to allow for differences in engine layout and the electronics fitted.
Is the engine the same age as the frame it's going into? Age differences can also affect the wiring layout.
You will need a wiring diagram for your bike and a separate one for the replacement engine. You will need the layout of the engine sensors as well.

Suzuki... | Answered on Feb 18, 2019 | 30 views


Check online Manuals lib.

Suzuki... | Answered on Feb 14, 2019 | 366 views


From left to right while sitting on the bike, it is 1-3-2-4

Suzuki... | Answered on Feb 10, 2019 | 418 views


Do you want the engine serial number, or the VIN number for the vehicle? The VIN is 17 digits, numbers and letters, on the right front frame downtube. It's the one required by law. The engine serial number on the casting somewhere near the rear wheel, if I remember correctly.

Suzuki... | Answered on Feb 09, 2019 | 26 views


Could be a number of things. My first question is when was the last time it was serviced ? Second, ( this might be the obvious ) are you down shifting to a low enough gear ? Is this the only symptom that you are experiencing, or does it back fire or hard to start ? First things I would investigate : 1. Air Filter. 2. Bad Gas / dirty Carb. . 3. Spark plug 4. intake gasket. 5. Charging system. (i.e. Stator, rectifier / Battery). If none of these help, it may be a more serious issue.

Suzuki... | Answered on Feb 08, 2019 | 34 views


its in the dead center of the bike see this video or follow the wiring harnesses to a black box snap off cover just above the lower frame 1 foot below your where your groin sits and on the right side usually

Suzuki... | Answered on Feb 08, 2019 | 26 views


Digital throttle body or is it a carburetor if it's a carburetor pry new gaskets if it's a throttle body by new gaskets if you can't get the gaskets buy a product called gasket maker kick it all apart and use gasket maker sparingly good luck let me know how you make out

Suzuki... | Answered on Feb 03, 2019 | 34 views


Normally you can go up one size, measure the width of a friends 160 tyre and see if you have enough clearance, a good tyre dealer can also help and may have already done this modification.

Suzuki... | Answered on Feb 03, 2019 | 345 views


remove the seat and fuel tank, try just removing the bolts at the back of the tank, there should be a rod the holds the tank when you lift up the back of the tank

Suzuki... | Answered on Feb 01, 2019 | 48 views


I got this free Pdf manual from an online store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the all the times I fixed the chipper in these 4 years

Suzuki... | Answered on Jan 30, 2019 | 33 views

Not finding what you are looking for?
2015 Suzuki RM-Z 250 Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...