Toyota Previa - Recent Questions, Troubleshooting & Support


The oil level sensor was either damaged, or it has failed. In any case, the oiul level sensor needs to be replaced.
Common problem.

The graciousness of a FixYa rating for my assitance would be appreciated. Thanks in advance.

1997 Toyota... | Answered on Jan 26, 2020


most of these models have 2 oil lights.The red one is oil pressure,if flashing or on when engine is running,it is usually serious.check oil level,but usually caused by blocked pickup screen(a common toyota fault) when services aren't done.The orange oil light is tripped by an oil level sensor on the side of the sump when the oil level is low.If the oil level is ok,note this is a common fault especially if oil changes have been missed,and/or a petrol engine oil used and sludge builds up,sometimes using an additive for flushing prior to oil change can help,but may not work on 1st oil change.

1993 Toyota... | Answered on Jan 26, 2020


This is slightly counter-intuitive, but the plastic lens needs to go in and up before it comes out. After removing the two screws, use something thin and flat to pull down on the underside painted part of the wing between the two screws. A little bit of prying downwards. Two raised lips become visible - they are holding the lens from being able to be pushed up and in. A second pair of hands could help. Then use your thumbs on the lens close to the screws, gripping with your fingers on the top of the wing and squeeze up. POP!

Toyota Previa... | Answered on Oct 09, 2019


Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother

Toyota Previa... | Answered on Sep 23, 2019


possible loose battery terminal or loose earth

1995 Toyota... | Answered on Aug 28, 2019


- Check the radiator cap for proper sealing.
- Blow air from outside and inside of the radiator to clean the fine dust accumulated in the feathers and fins.
- Check the radiator for clogged inside. Clean the radiator after disassembling it.
- Check the water pump belt for looseness or wear.
- Check the thermostat valve.
- Check the cylinder head gasket or re-torque the cylinder head bolts.

1994 Toyota... | Answered on Jul 22, 2019


Toyota Previa Questions - 93 toyota previa having white ...

www.cargurus.com > Questions > Toyota > Previa

CarGurusMar 17, 2013 - 93 toyota previa having white smoke while starting and stu-off while running on the road. ... Lift the cylinder head off the engine block and move to oneside. Remove the ... 1992 Toyota Previa 3 Dr LE Passenger Van ... was going down the road one day and it just shut off. it will turn over but wont crank.Missing: water

Rough idle, bad hesitation on acceleration, perfect idle with ...

repairpal.com > Questions > Toyota > Previa > 1994 Toyota Previa
1994 Toyota Previa Questions ... Idle is perfectly smooth for first 1 - 2 minutes after overnight cold start, before .... This may be because the throttle position sensor is signalling just off idle. .... My check engine light came on with PO-420 code. ... theengine was turning over under starter motor that would bring the engine to an ...

Re: Replacing a Previa head gasket. - ToyotaVanTech

www.toyotavantech.com > Forum > Technical Discussion > Toyota Previas

Dec 3, 2011 - 20 posts - ‎2 authors
Okay, so you've got a Toyota Previa with a blown head gasket. ... The next few pix are taken after dropping the engine out from the bottom using a ... You can see a definite path between the water jacket and the cylinder. ... I believe this was a result of #1blowing and over pressurizing the cooling system.

How to Change a Coolant Temperature Sensor - YouTube

? 26:00
https://www.youtube.com/watch?v=IXSp5ykI6po
Sep 16, 2012 - Uploaded by rehma6b0

1992 Toyota... | Answered on Jul 19, 2019


Hi

There is are 3 bolts securing the starter motor, the starter motor is located under the passenger seat area and should be accessed from under the vehicle. The key is to get the van high enough to be able to slide comfortable under the side of the van to access all bolts, only the bottom bolt has a bolt and a nut the other 2 bolts have threads which secure the starter motor onto the engine there is one bolt at the bottom, one bolt in the middle and one bolt near the very top you will have to undo the 2 x 10mm bolts that hold the dip stick first to be able to get to the middle and top bolt of the stater motor. take your time and have some patience you will get it it just takes practice.

1992 Toyota... | Answered on Jul 19, 2019


Hi

I am unsure if this is the only problem with the kick down cable but you may need to remove the bottom pan of the transmission to be able to disconnect or reconnect if you cant access it the change the kick down cable from the outside the transmission.

1993 Toyota... | Answered on Jul 19, 2019


Hi

It sounds like you have a loose connection either grab a torch and look under the dash as much as possible to see if any connections are loose or take it to an auto electrician and and ask for a quote to check out the issue.

Toyota Previa... | Answered on Jul 19, 2019


Does it have spark ? If it does can you spray some starting fluid into the throttle body and see if it starts ?

1997 Toyota... | Answered on Jun 07, 2019


p1215 is the educational circuit Injectors That ControlA Peaks is in the engine compartment and has 8 pin module is not Working with the ecu you got That review also That relay is in the circuit. on this page I hope you got the diagram to help you

http://www.moranbahweather.com/toyota/lc_trj12/rm/rm990e/m_05_0531.pdf

Toyota Previa... | Answered on Apr 02, 2019


Likely the ignition switch is not rotating completely into the off position. If your key is extremely worn, it may be possible it can be removed without the switch exactly in the off position. Suggest trying a different (less used) key and see if problem goes away.

Else try to make sure it is in off position (clock off) before removing key. If you find that's the problem you may need new keys or switch or both.

1994 Toyota... | Answered on Mar 02, 2019


Depends on where you're located . I can fix or replace the sunroof...

1993 Toyota... | Answered on Jan 30, 2019


If it has a fuse, or relay it will be in the fuse panel located under the hood on left side inner fender. (black box)

Toyota Previa... | Answered on Jan 16, 2019


The shaft has excessive clearance inside the distributor. Replace the distributor with a known good one or pick up a new one.

1991 Toyota... | Answered on Nov 06, 2018


go to a radiator shop and have the air removed
have them check for flow rate through the radiator cores
have a compression test done to check for head gasket or cracks

1994 Toyota... | Answered on Oct 04, 2018

Not finding what you are looking for?
Cars & Trucks Logo

1,588 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Toyota Cars & Trucks

  • Forum

View Most Popular

  • Toyota Cars & Trucks
Loading...