2001 dodge ram 2500 5.9 diesel all dash gauges quit working seat belt light is on check engine light is on etc.signal lights etc. work all right

Walker Muffler - Aluminized Steel Direct OE Replacement 1998-2001 Dodge Ram 1500.-------------------------------------------------------------------------------------
SLIM HID XENON light

I am working on the same problem now, could be cluster, short, pcm, ctm, etc, expensive and frustrating. will notify you with the fix.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L Turbo Diesel 6cyl the Fuel Filter is located under hood, passenger side, lower engine area, mounted above starter.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L SFI 8cyl the Fuel Filter is located under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.

Hope helps with this (remember rated the help).

check the engine to body ground strap. located rear top of engine screwed to firewall Remove,clean, and resecure.

replaced the IPM (the fuse box) it was shorted

Installation > 5.9L Diesel Engine 5.9L Diesel Engine
WARNING Do not attempt to check belt tension with a belt tension gauge on vehicles equipped with an automatic belt tensioner.

Drive belts on diesel engines are equipped with a spring loaded automatic belt tensioner. This belt tensioner will be used on all belt configurations, such as with or without air conditioning.

1. Depending on the year of the vehicle, a 3/8 inch or 1/2 inch square hole is provided in the automatic belt tensioner. Attach a 3/8 inch or 1/2 inch drive-long handle ratchet to this hole.
   
2. Rotate ratchet and tensioner assembly clockwise (as viewed from front) until tension has been relieved from belt.
   
3. Remove belt from water pump pulley first.
   
4. Remove belt from vehicle.
   

To install:

WARNING When installing the accessory drive belt, the belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction. The correct belt with correct length must be used. Position drive belt over all pulleys except water pump pulley.

1. Attach a 1/2 inch ratchet to tensioner.
   
2. Rotate ratchet and belt tensioner clockwise. Place belt over water pump pulley. Let tensioner rotate back into place. Remove ratchet. Be sure belt is properly seated on all pulleys.
   

Sounds like a short in your wiring. Have you checked the bulbs and you could have bought a bad brake light switch. Try having somone step on the brake lights and use a test light to see if your getting current back there

there is a cruise control module , easiest way to find it is follow 2nd throttle cable under hood right to it. it most cases there unplugged

Hi my name is Allen!

The most probable cause for your problem is the heating grid that is mounted on the set for heating it, it is under the seat cover, the light will act weird because it is not completing the circuit. Raise the seat cover and visually look at it, it should be burnt.

For further asistance you may reach me at FixYa!

check the fuse that are labeled park lights or tail lights.

tnx 4 using fixya,

drcool