Question about Chevrolet K2500
SOURCE: no dome light on tacoma
The dome light gets 12 volt battery power at all times. The door switch, when the door is opened, allows the current to flow to ground, and completes the circuit. The door switch allows the ground to be made. Measure for 12 volts at the wiring connector, and measure for direct short at the ground wire, with the door open. The Ground wire is white with a black tracer.
Posted on Feb 27, 2009
make your self a jumper set of wires to test with. Find out what makes what move on the old unit,write down the color wire,then apply power and ground to the new unit onw wire at a time.Mark down the color and what function it did.after testing both units then match your research and put the wires together.I wished I were there.Good Luck!
Posted on Jul 24, 2009
The Best diagram you can get is at alldatadiy.com it has the sections and locations and color of wires with pictures.
Posted on Aug 20, 2009
I don't have a diagram but they are under your intake manifold. It's not to bad of a job. You don't have to remove the fuel rails or the injectors, they can come up with the intake. The #2 knock sensor is the one in the rear. I will suggest getting both of them and also the harness and do it all while you have it apart. I believe you will find that water has gotten down in the hole where the knock sensors are located. Make sure to clean it out very good with compressed air before you install your new knock sensors.
Posted on Oct 14, 2009
Tips for a great answer:
Oct 10, 2016 | Cars & Trucks
Mar 07, 2015 | 2002 Chevrolet Silverado
Aug 03, 2010 | 1989 Chevrolet Silverado 2500
Jul 08, 2010 | 2004 Chevrolet Silverado 1500 Crew Cab
Jun 09, 2010 | 2003 Chevrolet Silverado 1500
Jan 06, 2018 | Cars & Trucks
Mar 26, 2010 | 2000 Chevrolet Silverado 1500
Nov 29, 2009 | 1994 Toyota Pickup
Aug 20, 2009 | Chevrolet 1500 Cars & Trucks
Apr 24, 2009 | 2000 Chevrolet Blazer
25 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: