Question about 2003 Ford Crown Victoria

Open Question

2003 ford crown victoria. had wierd clicking sound at front of motor. While trying to figure it out car overheated. found the fan to be bad. replaced fan with aftermarket. Everything seemed to be working correctly. Drove home with ac on, all good. Shut off car fan kept running. drove car again. fan not running. Have main power from 50amp fuse at plug. not getting any power to control wire with ac or defogger on, had car idling in drive way and can't confirm if it ever hit the temperature set point for fan, needle never went above mid range.

Posted by Anonymous on

Ad

5 Related Answers

Anonymous

  • 324 Answers

SOURCE: Ford Crown Victoria overheating

your head gaskets are bad, this is the only thing that will cause this problem.

Posted on Nov 26, 2008

Ad

Anonymous

  • 28 Answers

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

Posted on Mar 19, 2009

Ad

Anonymous

  • 33 Answers

SOURCE: need wiring diagram for 2008 ford crown victoria

Hello,

You can purchase the wiring diagram for $5.99 from the following site: http://www.wiring-diagram.com/. You can also purchase a wiring diagram book from the following link: http://cgi.ebay.com/ebaymotors/2008-FORD-CROWN-VICTORIA-MARQUIS-WIRING-DIAGRAM-MANUAL_W0QQitemZ120394723100QQcmdZViewItemQQimsxZ20090320?IMSfp=TL090320147007r15080.

Hope this helps,

Chris

Posted on Mar 23, 2009

michael wiggins

  • 135 Answers

SOURCE: clicking fuse box. car won't start. totally dead

check battery & terminals

Posted on May 12, 2009

Anonymous

  • 31 Answers

SOURCE: 2000 crown vic motor overheating and freezing up after 1/2 hour. New oil, fan, thermostat. water level ok. A/C was on.

Is the engine itself hot? or the car? If the engine is warm, check the engine coolant, and see if their are any holes or leaks..

Posted on May 23, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 V8 4.6l. It turns over, but why won't it start?


Part 1 -How to Test the Starter Motor (Ford 4.6L, 5.4L)

troubleshootmyvehicle.com > Ford > 4.6L, 5.4L
Mar 2, 2011 - Page 1 of 3: How to test a BAD Starter (Ford 4.6L and 5.4L Pick Up and SUV). ... a BAD starter motor on your 4.6L or 5.4L V8 equipped car, pick up or SUV. ...and will turn over the engine; -OR-; The starter motor won't do a thing. ... Crown Victoria ... 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005.

Question: 1997 Crown Victoria Lx Cant Turn on and Cant ...

www.2carpros.com/.../question-1997-crown-victoria-lx-cant-turn-on-an...
May 26, 2014 - Ok so i put the keys in the car turn the key but seems to me it moves more ... 1997 Ford Crown Victoria • 4.6L V8 RWD Automatic • 99,625 miles ... Keywon't turn off accessories or turn car over and ignition cylinder turns too ...

Oct 19, 2015 | Ford Crown Victoria Cars & Trucks

2 Answers

2003 crown victoria overheats when a/c is on


A bad fan motor or controller maybe? Check for debris between condenser and radiator,clogs up with leaves and dirt ,have to blow out with compressed air.

Jun 02, 2014 | 2003 Ford Crown Victoria

1 Answer

2003 landrover freelander high pitched screaching from under front of motor when turning motor over


Sounds like you have a bad component on your drive belt or you need starter shim

May 02, 2014 | 1994 Ford Crown Victoria

2 Answers

Diagnois overheating on 2003 Ford Crown Victoria police interceptor


Does the cooling fan come on at 225F? Have the fan tested by the dealer with a scanner.

Jul 02, 2012 | 2003 Ford Crown Victoria

2 Answers

'99 Ford Crown Victoria temperature gauge shows overheating and sets off alarm when driving with AC on - usually anywhere from 30 to 70 M.P.H. Quickly stop - lift hood - no sign of ...


ok lets see if we can help u out
some cars also have a fan in the front that is for the AC condenser go to the front of the car and look through the grill if you see a fan in side the grill start the car up turn on the ac and look to see if that fan comes on if it do not come on u may need to replace it also look to make sure the radiator is not dirty so air can go through it

good luck

Oct 14, 2011 | 1999 Ford Crown Victoria

1 Answer

1994 Ford Crown Victoria power front window will not go up or down but I can still hear the motor


if it sounds kind of grinding the regulator is bad, it is cable driven and
whenit goes bad the window wont move but the motor still runs

Aug 06, 2010 | 1994 Ford Crown Victoria

1 Answer

Wipier motor burnt out on 05 crown victoria?


Either the motor winding shorted or; the connectors on the motor are loose/corroded causing arcing and overheating or; the linkage is binding putting too much load on the motor.

Sounds like the wiper motor needs replacing.

Charlie

Aug 20, 2009 | 2005 Ford Crown Victoria

1 Answer

2004 crown victoria heater fan not working, fuses OK. motor OK Power at motor, No ground at motor. Is the problem a resister.


You are most probably correct, fan motor resistor is usually found at the top center of firewall in engine compartment.

Aug 02, 2009 | 1989 Ford Crown Victoria

Not finding what you are looking for?
2003 Ford Crown Victoria Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...