1989 Mazda RX-7 Logo

Related Topics:

Posted on Jul 11, 2011

I have a 1989 RX7, the tail signal lights do not work when engaged, and do not show on the dash. I have already replaced the flasher unit, still nothing. What could be done to fix this?

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Dec 18, 2008

SOURCE: can't find the turn signal or emergency flasher fuse for 1998

Conrad, up north.
My protege is a '99. The turn signals and hazard flashers use the same flasher unit. It is located under the dash to the left of the steering wheel and above and a bit to the right right of the driver's side fuse box.

Ad

Anonymous

  • 1990 Answers
  • Posted on Jan 22, 2009

SOURCE: how do I replace the Turn signal/Emergency flasher relay.

This is Located Under the Dash on the Drivers Side Fuse Panel at the Very top of the Panel. Get down there and try the Blinkers, You will here it trying to work. Not hard to get to.

Anonymous

  • 217 Answers
  • Posted on Jan 31, 2009

SOURCE: Turn signal does not flash right or left. Where is flasher unit?

yes it is the same. the problem is most likely the turn signal switch which is located on the steering column. be sure to check all fuses, relays, and bulbs first. keep me posted thanks

Anonymous

  • 1 Answer
  • Posted on Jun 20, 2009

SOURCE: Turn signal stopped working 1990 Mercury Cougar

I had the same problem and the flasher is not located in the fuse box because it is not a normal flasher. the cougar has an electronic flasher unit that is located on the left side of the center console. the best and cheapest place to order a new one is amazon.com. they run about $30-$40

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Aug 22, 2009

SOURCE: I have a 1989 525i BMW and the tail lights are not

checked the bulbs ,do the number plate lights work??

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

89 jeep cherokee blinkers and hazards not working

For 1989 Jeep Cherokee the Flasher is located:
* Front seating area, driver side, under dash, above kick panel, mounted in bottom of convenience panel for Hazard flasher
* Front seating area, driver side, under dash, above kick panel, mounted in top of convenience panel for Turn signal

Hope helps.
1helpful
1answer

Turning Signals not working

if 4way flashers work & no signal,,,i would replace signal flasher,,,there are two flashers ,,,,
1helpful
1answer

Turn signals do not work

This is one FLASHER fault; ?m referring to the blinker "flasher fuse", it is the bottom round fuse under the dash in the fuse block.

REPLACEMENTThe turn signal flasher and hazard units are usually located located under the dash either to the left or right of the steering column on most models.
  1. Remove the turn signal flasher unit or hazard unit by pulling them up from the electrical connection.
  2. To install, push the unit(s) into the electrical connector

Good luck (remember comment and rated this).
0helpful
1answer

1989 chevy 1/2 ton.brake lights or emergency flashers dont work.tail lights an blinkers work.

The Blinkers and the Brake Lights are the same bulb. So check the brake light switch. Flashers use a different flasher unit, than the turn signals
0helpful
1answer

Where is the exact location of the hazard light flasher for a 1989 GMC Sierra C2500, and what is the possibility that it is the true problem behind the hazards not working? Beyond my hazards not working my...

Are you sure the right side bulbs all flash? You say you replaced all the bulbs? Why would you replace bulbs that were working? Did you have this problem before you replaced the bulbs, or after. The hazard flasher is down under the dash, left side, turn the signals on and follow the clicking noise.The hazard flasher and the turn signal flasher should be near each other, and are interchangeable. If it clicks fast, a bulb or a bad socket is usually the cause. These trucks have a lot of problems with the tail light circuit boards.
0helpful
1answer

Right rear blinker problem

CHECK PIG TAIL AT RIGHT REAR TAIL LIGHT IF LOOKS BAD OR BURN REPLACE IF OK FIND FLASHER UNDER DASH AND REPLACE.
0helpful
1answer

Turn signals and brake lights won't work on my

try replacing the flasher first. and check the two fuses for hazards and signals.
0helpful
2answers
0helpful
2answers

Signal light so fast

Try replacing the flasher unit.
Not finding what you are looking for?

108 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...