I need to replace the horn but don't know where it's located

You could always call a <a href="http://www.norrismechanical.com/hvac/">heating and ac company</a>. That could help.

Don't know what kind of car you have but the horn is usually mounted in the grille area at the front of the radiator.

The horn is located on in the right front fender behind the wheel well.You need to remove the plastic cover around the front part of the wheel well and pull it back enough to see the horn.Remove the wire from the horn and you can use a test light to see if you are getting power to the horn.The ecm(engine control module) is right by the horn so be careful with the wires harness.If you don`t have a test light you can use a piece of wire and hook it to the battery and put power to the horn.It should beep.If not replace the horn.If it does work then you will need to trace the wire back to the relay center under the hood.Hope this helps.Good luck.

disconnect the negative batery terminal be fore you mess with the horn. the cover should come off easily and you will the wire for the horn on my car the wire is green

LOOK UNDER THE LOWER AIR DEFLECTOR FROM BELOW THE RADIATOR. IF YOU HOT WIRE CAR HORN AND IT WORKS.YOU HAVE TO REPLACE THE WHOLE AIRBAG IN STEERING WITH HORN CONTROL BUTTONS.YOU NEED TO DISABLE AIRBAG IN STEERING WHEEL WHEN REPLACING AIRBAG AND HORN CONTROL BUTTON PAD.JUST TURN OFF RADIO FIRST, THEN DISCONNECT REMOVE THE NEGATIVE BATTERY CABLE.WAIT 20 MINUTES BEFORE WORKING ON AIRBAG AND HORN PAD IN THE STEERING WHEEL.

I don't see a fuse for the horn but I can tell you the horn relay is located in the power distribution box located under the hood of the car in the engine compartment on the drivers side of the vehicle. Below is a diagram of the fuse layout. The horn relay is the one marked "R6". This should be in your owners manual if you have one. If you don't and would like a copy, you can email me at [email protected] with your make, model and year and I will be happy to email you a copy. No worries, no cost for it. I hope this helps and good luck.

If the abs light is on and the horn does not work generally it's due to a broken "clockspring" in the column. You can replace that but definitely need a haynes or chlton manual to use as a guide. If you do the repair without instructions or don't follow them exactly, the air bag can deploy in your face (hurts a lot....dangerous). If only the horn isn't working, I'd get another opinion before allowing anyone to do the job. The clockspring and airbag are separate items and I don't see a reason to be replacing the airbag (unless the dealer found something I'm unaware of, but I doubt it).

easy check first ,, you need help,, disconnect the 2 wires at the horn itself, Located by the front gill under the hood,, use a multimeter to check for power,, have someone try and honk the horn to see if the horn itself is receiving power, if it is,, the horn went bad, if not,, the contacts in the horn contacts are bad, which doesn't happen often but it does happen, or ( and I don't know on your model, ) you may have a horn relay thats not working, I'll check more to see if I can locate that answer

possible horn itself is faulty and needs replacing. you will need to locate where the horn is and apply power to the horn from the battery. if the horn sounds then you know that it is a broken wire th=o the horn

I have or should say had same issue on 1996 cirrus quick fix just remove the HORN RELAY located on the left side of dash relay only controls horn. To really solve the issue at hand you must replace the clock spring on the steering wheel dis-arm air bag before messing with steering wheel to avoid activation of air bag disconnect battery for 10 min then its safe to fiddle with steering wheel safely.
Chino S.G.V