1996 Subaru Legacy Logo

Related Topics:

Posted on Jul 06, 2011

My dash lights are not working , all the fuses are all good and everything esle works fine it a 96 gt legacy

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 7 Answers
  • Posted on Jul 06, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jul 06, 2011
Answers
7
Questions
0
Helped
2090
Points
9

You will need to pull the cover off of the guage assembly. There are little light bulbs inside that have probably burned out. Replace them and your dash lights should work again. Hope this helps. Good luck.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

No power to gauges or dash lights everything else works fine

Sounds like you blew a fuse in the fuse box should tell which fuse is what on most covers Good Luck Mike
0helpful
1answer

My dash lights on my 1997 subaru legacy outback just stopped working out of no where, What could be the problem?

ok fuse boxes are under the hood and under the dash around the hood release lever. should be the 5A fuse
5helpful
3answers

The battery went dead in my 97 subaru legacy gt and was dead for a while. i relaced the battery and now the parking lights blink and when i start the car it wont idle it shuts off. does something need...

Under the dash to the left of where your left leg would sit is a box. 4" x 4". It is your security box. There is either a red button on it or a wire with a button. push the button for about 15 seconds and it will reset the security system. Good luck and have a great day.
0helpful
2answers

Subaru legacy 96 running tail lights out

The globes on tail lights are usually 2 elements so just because ur brake when pressed works doesnt mean the second part of the globe is working id buy new tail light globes or at least see if both little wires are going from one point to the other it looks like 2 little power lines .if top and bottom are both going to the other side tgen its another prob but if top or bottom line are broke then thats the problem hope i didnt confuse u but im sure u will get what i mean when u have alook at the globe
0helpful
1answer

I have a 96 geo tracker and it blows the 15 amp fuel injection fuse. I unpluged all the wires in the engine comp. and the relay under the dash for the fuel pump. After that the only on that made it blow...

most car have 2 kind of ground...the relay and the fuel pump...make sure u check them both...if not...than disconnect the - side of the batt than put a test light on the - side of the batt and the other one on - side of the cable...make everything is off n all doors are close...if it light up then start pullin fuse one at a time to see if it will off...it will lead u closer to ur problem...good luck
0helpful
1answer

My dash lights quit working on my 98 Ford Mustang GT. I checked the fuse and my tail lights and brake lights work. everything else works. What else could it be.

the headlight knob is also a dimmer for the lights on the dash. try turning it all the way one side, then check fuse if still not working.
1helpful
2answers

96 subaru no power to the master window switch

look under passnger seat and carpet this where the circuit breaker is located most likely you'll find a corroded solder joint 6-8 inches away from it,good luck
Not finding what you are looking for?

489 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...