Ask q 1 from code landing - A5 Audi Cars & Trucks

You need a good auto-electrician, or an alarm installer to reprogram it. They have programming computers that tell the vehicle what the code is, rather than asking it..

CHECK ON YOUR SERVICE PORTFOLIO FOR THE CODE OR CONTACT THE NEAREST LAND ROVER REPRESENTATIVE AROUND YOU.

code p0130 refers to heated oxygen sensor (HO2S) 1 bank 1---circuit malfunction causes ---heating inoperative---poor connection---wiring--- HOS I would replace the sensor with a genuine unit to match the cpu settings

PLEASE RATE THIS REPLY FOR ACCURACY

tahe out the radio call the dealer and tell him the numbers in the back of the radio will give it to you they night ask the vin number

Leave the radio on, until it displays the word "CODE".
then you can enter the code using numbers 1 to 4.

The time until "CODE" is displayed depends on the number of previous wrong entries. 1 minute for one wrong entry, 2 hours for 5 wrong entries.

Just put the radio on and leave it that way until it says "CODE"

sometimes people write it on the top of the radio.if not then contact the landrover dealer that supplied the car new,tell them that you are the owner,they will need proof so have it ready as they will ask you questions.also contact www.land rover .co.uk,and tell them the chassis number and they will give you the code.adrian.

Press the station buttons if the code is 3 6 5, press 1 three times press 2 six times and so on when all the code is in press the next button this should bring on the radio.

call the person dealer and ask them him her for the code

It is usually listed in the top section of repair invoices from a dealership.
If you still cannot get the code. there are many sites on the internet that can
supply the code for a fee.

Radio codes are only available from the Dealer, you need to goto the dealership with your registration, they will type in your Vehicle Identification Number in there system and give you a 4 or 5 digit code. If you have typed buttons on the radio (3 incorrect codes) the radio will go to a lock-out mode and you will have to leave the key on position 1 for 1 hour to reset the lockout mode.
Hope this helps.
JPTCAT