SOURCE: serpentine belt for 1998 mercury tracer
Hey there MSM,
Mike
SOURCE: 1993 mercury tracer
To replace the headlight on a 1993 Tracer you must turn the black plastic retainer ring counter clockwise and then pull back gently. The ring and bulb should then slide out toward the engine.
Carefully grab the sides of the plug and pull the bulb out.
When replacing the bulb make sure not to touch the glass part or it will cause the bulb to burn out sooner. Place the black ring back over the bulb with the open end towards the glass part of the bulb. Fit the wiring onto the back of the bulb and insert the bulb back into the reflector. The black plastic ring has notches that fit over protrusions. Turn the black ring clockwise and your done. Test the headlight. Happy Driving
SOURCE: replacing door speakers in a mercury tracer
first remove any screws in door panel, then remove lock and window controls, then take flathead screw driver and SLOWLY pry panel off door. You now will have access to speaker. Speaker is held by 4 screws and wire harness that unclips.
Reverse procedure to reinstall. Door panel pops back in the wholes to reattach
SOURCE: Removal of front trans-axle of 94 mercury tracer
The center nut or the wheel bolts ?????
Testimonial: "center nut"
SOURCE: door wont open
you have to pull on it, not push.
Testimonial: "I pulled on it and it still did not open, so I unlocked it and got out. thanks so much"
47 views
Usually answered in minutes!
What is a "gad" line?
×